Hurricane code · Coconut Creek · Broward County

Which hurricane code applies to windows in Coconut Creek?

Coconut Creek is in Broward County, so the High Velocity Hurricane Zone rules apply across the whole city, even though it is inland. Windows and doors need a Miami-Dade NOA or an HVHZ-approved Florida Product Approval, and permits go through the city Building Department's ePermits portal.

Last checked: November 3, 2026 · General information, not engineering or legal advice. Confirm requirements for your address with the building department.

Inland city, coastal rules

Coconut Creek is several miles from the beach, and that confuses people. Some contractor pages say the city is outside the High Velocity Hurricane Zone. Others say inside. The code settles it.

The 2023 Florida Building Code, 8th Edition, defines the HVHZ as Broward and Dade counties. Coconut Creek is in Broward. So the HVHZ provisions apply to every street in the city, from the older condos near Lyons Road to the new construction planned west of it.

The design wind speed follows the same logic. Section 1620.2 sets one countywide figure for Broward: 156 mph for Risk Category I, 170 mph for Category II, 180 mph for Category III and 185 mph for Category IV. A typical Coconut Creek house is Category II, so it is designed to 170 mph. That is the same number used for a beachfront home in Pompano Beach or Deerfield Beach.

What is different about Coconut Creek homes

Coconut Creek was incorporated on February 20, 1967, and the 2020 census counted 26,971 housing units.

The median home was built in 1989, according to ACS 2023 data reported by City-Stats. That is before the 1994 South Florida Building Code changes that followed Hurricane Andrew. So roughly half of the city's homes were built under older rules, and many still have original windows and doors.

Two kinds of housing matter most: large condo communities such as Wynmoor Village, and new construction on former farmland.

Where the code questions come up

Coconut Creek areas and what to check
AreaWhat the research showsWhat to check
Wynmoor Village (ZIP 33066)Gated 55+ condominium community with thousands of homes, described as built between 1978 and 1999. Listings show buildings from the mid-1970s.Association approval, milestone or Broward inspection status, and original openings
City Hall area (Government Center, 4800 West Copans Road)Home of the Building Department that permits windows and doors.Which office handles your permit
Mainstreet at Coconut Creek, between Wiles Road and West Sample Road, west of Lyons RoadPlanned 12-block district on about 170 acres of former farmland, with apartments, townhomes, villas and condos.New buildings follow the current Florida Building Code
Homes built before 1994About half the city, judging by the median year.Product approvals and anchoring when openings are replaced

The Coconut Creek Building Department

Coconut Creek runs its own building department. Broward County's ePermits support page lists the city's contact line, which confirms the city does not hand permits to the county.

The Building Department (Building Division) is in the Coconut Creek Government Center, 4800 West Copans Road. The main line is 954-973-6750 and the email is ebuilding@coconutcreek.gov.

  • Contractors submit through the city's ePermits portal with their own logins. The city publishes a 10-step ePermits tutorial.
  • Owner-builder permits are different. They are applied for in person, and the city asks owners to email the Building Division first about the documents.
  • You can verify and track a permit through the city's E-Services and Permit Status tools.
  • Permit fees are published in the city code on Municode.

How a window replacement is documented in Broward

For detached one- and two-family homes and townhouses under 30 feet, Broward's Board of Rules and Appeals Formal Interpretation #24 governs window, door, garage door and shutter retrofits. It was approved October 12, 2023 and reissued January 9, 2025, and it applies in every Broward city, including this one.

Each opening needs a documented design pressure. There are three ways to show it: a signed and sealed site-specific plan by a Florida engineer or architect; an unsealed site plan with a sealed worst-case pressure chart; or an unsealed site plan using the Broward County Fenestration Voluntary Wind Load Chart. Above 30 feet of mean roof height, only a sealed site-specific design is accepted.

The chart is based on ASCE 7-22 and stops at 30 feet.

Broward cities attach the Uniform Retrofit Window & Door Schedule (BORA Policy 20-01, effective July 1, 2020). It lists each opening with its product approval, size, design pressure and anchorage.

  1. Pick approved products. Look up the Miami-Dade NOA or Florida Product Approval number. For the HVHZ, the Limits of Use must say the product is approved there.
  2. Document each opening. Fill in the retrofit schedule and choose one of the three pressure methods.
  3. Submit the permit. A contractor uses ePermits. An owner-builder goes in person.
  4. Record the Notice of Commencement. When the direct contract is above the statutory threshold, Florida Statute 713.135 requires the recorded notice before the first inspection.

What approval label to look for

In the HVHZ a window or door needs a Miami-Dade Notice of Acceptance (NOA) or a Florida Product Approval (FL number). Not every Florida Product Approval covers the HVHZ, so read the Limits of Use on the floridabuilding.org record.

HVHZ testing uses TAS 201 for large missile impact, TAS 202 for static pressure and TAS 203 for cyclic loading. The missile is a 9-pound 2x4 timber at 50 feet per second, for assemblies used up to 30 feet in height.

Shutters are an option too, since the retrofit rules cover them. They still need an approval that fits the HVHZ.

Condos, Wynmoor and the inspection clock

Wynmoor Village is a gated community with guard gates at Coconut Creek Parkway and Lyons Road. Its oldest buildings date to the mid-1970s.

Florida Statute 553.899 requires milestone inspections of condominium buildings three or more habitable stories tall by December 31 of the year they reach 30 years from the certificate of occupancy, then every 10 years. Broward's Policy 05-05, effective August 9, 2024, replaced the old 40-year program with a Building Safety Inspection Program at 25 years and every 10 years after. That inspection counts as compliance with the state law.

One-to-four-family dwellings of three or fewer stories, fee simple townhouses and buildings under 3,500 square feet are exempt. We did not confirm how many Wynmoor buildings reach three stories, so ask your association which rules apply to your building. Windows and doors are usually common elements or association-controlled, so ask the board before ordering anything.

Flood maps and storm history

The city says the latest FEMA flood maps were issued August 18, 2014, and many areas changed designation. To confirm your zone, call the Utilities & Engineering Department at 954-973-6786. The Building Division, 954-973-6750, handles permits. The city also publishes map atlases showing flood zones with street addresses.

The nearest official weather station is in Pompano Beach. In Hurricane Wilma on October 24, 2005, it recorded 83 mph sustained wind and a 98 mph gust. These are nearby readings, not Coconut Creek measurements.

Insurance paperwork and state rules

A wind mitigation inspection on form OIR-B1-1802 can document opening protection for your insurer.

Florida Statute 553.844 also matters for older homes. It can require opening protection when large permitted work is done on a high-value home in a wind-borne debris region. Ask the Building Department whether your project reaches those thresholds.

Before you order

Check three things first: your association rules, your building's inspection status if you live in a condo, and the product approval numbers. To match sizes to approved products, send your measurements to SmartWay at (754) 303-7130 and ask for a written quote.

The county rules are the same in neighboring Broward cities, but the office, portal and owner-builder process above are specific to Coconut Creek.

Coconut Creek questions

Is Coconut Creek in the HVHZ?
Yes. The Florida Building Code defines the HVHZ as Broward and Dade counties, and Coconut Creek is in Broward. Being inland does not change that. Some contractor pages say otherwise, but the code definition controls.
Do I need a permit to replace windows in Coconut Creek?
Yes, window and door replacement is permitted through the Coconut Creek Building Department. Contractors file in ePermits. Owner-builders apply in person after emailing the Building Division at ebuilding@coconutcreek.gov.
What wind speed are windows designed for in Coconut Creek?
A typical house is Risk Category II, designed to 170 mph (3-second gust) under FBC 2023 Section 1620.2. Categories I, III and IV are 156, 180 and 185 mph. The figure is the same countywide.
Can I use shutters instead of impact windows in Coconut Creek?
Broward's retrofit rules, Formal Interpretation #24, cover shutters alongside windows and doors. Shutters still need a product approval valid for the HVHZ and a documented design pressure for each opening.
Does my Wynmoor condo need association approval to change windows?
Check your association documents first. Condo windows are often association-controlled, and we did not confirm Wynmoor's rules. The city permit is separate from association approval, so you may need both.
Does the 40-year recertification apply to my Coconut Creek condo?
Broward replaced the 40-year program in August 2024 with inspections at 25 years and every 10 years after. Some smaller buildings are exempt, so ask the Building Department whether yours is included.