Hurricane code · Miami · Miami-Dade County
What hurricane code applies to windows in Miami?
Every home in the City of Miami sits in Florida's High Velocity Hurricane Zone, so new windows and doors must pass HVHZ missile and pressure tests and carry a current Miami-Dade NOA or Florida product approval. Homes are designed for a 175 mph wind speed, higher than Broward, and permits go through the city's iBuild portal.
Last checked: October 24, 2026 · General information, not engineering or legal advice. Confirm requirements for your address with the building department.
Why Miami has the strictest window rules in Florida
The Florida Building Code names only two counties as the High Velocity Hurricane Zone (HVHZ): Broward and Miami-Dade. The City of Miami is inside it, so every window and door you replace is held to the HVHZ chapters of the code, not the lighter rules used in most of the state.
Even inside the HVHZ, Miami-Dade is designed for stronger wind than its neighbor. Section 1620.2 of the 2023 code sets the design wind speed for a typical home (Risk Category II) at 175 mph in Miami-Dade, compared with 170 mph in Broward. That number feeds the pressure calculation for each opening.
Miami-Dade is also where the county product approval comes from. Its Notice of Acceptance (NOA) program, run by the Product Control Section, is the approval most HVHZ windows are sold under.
| Risk category | Miami-Dade |
|---|---|
| I (low-hazard) | 165 mph |
| II (homes) | 175 mph |
| III (high-occupancy) | 186 mph |
| IV (essential facilities) | 195 mph |
From Hurricane Andrew to today: which code era is your home?
Miami's window rules were written after Hurricane Andrew. The storm made landfall at Fender Point near Homestead Air Force Base at 5:05 AM on August 24, 1992, as a Category 5 with 165 mph sustained winds. The National Weather Service counts about 49,000 houses destroyed and 108,000 damaged, almost all in southern Dade County.
In 1994 an enhanced South Florida Building Code for Broward and Dade added hurricane mitigation rules. The first statewide Florida Building Code followed in 2002. Today, permits are reviewed under the 8th Edition (2023), in effect since December 31, 2023.
The City of Miami's housing is older than many people expect. The median home was built in 1984, before the post-Andrew rules.
- Replacement windows must meet the current code, not the code your home was built under.
| Built | Share of units | What it usually means for windows |
|---|---|---|
| Before 1950 | About 16% (37,627 units) | Pre-code era; many sit in historic districts that add a design review |
| Before 1980 | About 47% | Built long before HVHZ impact testing |
| Before 1990 | About 55% (125,345 units) | Still pre-Andrew; original openings need full replacement to meet code |
| 2000 or later | About 40% (92,492 units) | Built under the 1994 South Florida code or later; check whether openings are impact or shutter-protected |
Product approval: the Miami-Dade NOA and Florida approval
Miami-Dade's permit rules ask for the current approval document for each product type on the job. A Miami-Dade NOA is accepted, and so is a Florida Building Commission product approval. Expired approvals, or ones from an older code cycle, are not accepted.
An NOA is earned by passing three test standards: TAS 201 (missile impact), TAS 202 (uniform structural load) and TAS 203 (cyclic pressure). A product with a Miami-Dade NOA is approved for use in both Miami-Dade and Broward.
NOAs carry an expiration date and usually state that the product meets the code including the HVHZ. Many also require a permanent 'Miami-Dade County Product Control Approved' label on the unit and county-approved anchors when installed in concrete or CBS walls.
- Large-missile test (FBC 1626): a 9-pound 2x4 fired at 50 feet per second, two hits per sample, then cyclic pressure. Essential facilities use 80 feet per second.
- Small-missile test (2-gram steel balls, TAS 201 and TAS 203): applies to units installed more than 30 feet above grade, which covers upper floors of Miami's towers.
- The approval must match the size, design pressure and mullion at each opening, not just the product name.
Most Miami homes are in large buildings, and that changes the rules
Miami is a city of towers. About 43% of its housing units (99,923) are in buildings with 50 or more units, and about 60% are in buildings with 10 or more. Single-family detached homes are only about 21% (49,360 units), with another 9% in townhouse-style attached homes. Brickell alone has about 40,000 residents, mostly in high-rise towers.
Only about one in three occupied homes in the city is owner-occupied (ACS 2024), compared with 52.2% countywide in the 2019-2023 QuickFacts. If you rent, the owner or association controls window work. If you own a condo, your association's rules and the building's engineering usually come first.
- Threshold buildings: over three stories or over 50 feet tall. Window and door work needs a threshold inspection by a State of Florida Special Inspector, an inspection plan from the design professional, and wind calculations for every opening under FBC 2023 Section 1620 and ASCE 7-22.
- Milestone inspections (Florida s. 553.899): condo and co-op buildings three or more habitable stories must be inspected by December 31 of the year they reach 30 years from their certificate of occupancy, then every 10 years. A local agency may require it at 25 years for buildings near salt water.
- Miami-Dade's own recertification program moved from a 40-year to a 30-year cycle effective June 1, 2022, and a county recertification counts as the state milestone inspection.
- Permanent storm shutters need the association's expressed approval before a permit is issued, and permanent shutter work on condos and apartments needs zoning review.
Bayfront neighborhoods: storm surge and flood zones
Wind is only half of Miami's exposure. During Hurricane Irma on September 10, 2017, the Weather Service recorded a 99 mph gust at the FAA site in Miami. Storm surge put 3 to 5 feet of water along the Biscayne Bay shoreline from Homestead to Downtown and Brickell, peaking slightly above 6 feet in spots in Coconut Grove and Brickell, and about 2 to 3 feet north of downtown.
FEMA's 2024 preliminary flood maps for the City of Miami show Zone AE and coastal velocity Zone VE along the bay. These panels are preliminary, so check the effective flood map for your address before you plan work on ground-floor openings.
Historic districts: a second approval before the permit
The City of Miami requires a Certificate of Appropriateness (COA) for any work on a historically designated property, and it names window replacement as one of the small projects that still needs one. The COA comes on top of the building permit.
Minor work gets a staff-reviewed Standard COA. Larger changes need a Special COA heard by the Historic and Environmental Preservation Board (HEPB); past agendas include requests to switch Morningside windows to horizontal sliders.
- The city lists nine historic districts: Bayside, Beverly Terrace, Buena Vista, Downtown Miami, Lummus Park, MiMo/Biscayne Boulevard, Morningside, Palm Grove and Riverview.
- Morningside (designated 1984) runs from Biscayne Boulevard to Biscayne Bay between NE 55th and NE 60th Streets.
- Palm Grove (designated 2009) is the city's largest district, with a period of significance of 1921 to 1959, bounded by the Little River, NE 58th Street, Biscayne Boulevard and the FEC Railway.
How a window permit works in the City of Miami
Inside city limits, permits come from the City of Miami Building Department at the Miami Riverside Center, 444 SW 2nd Ave, Miami, FL 33130 (phone 311 or 305-468-5900). If your address is in unincorporated Miami-Dade or another city, a different office handles it.
- Owner-occupied one- and two-family homes can use an owner-builder permit, but the owner must pass an Owner/Builder test in person at the Miami Riverside Center.
- Confirm historic or association status. Line up any COA or condo/HOA approval first.
- Match each opening to an approval. List every window and door with its size and the NOA or Florida approval number that covers it, plus mullion sizes. Miami-Dade's replacement checklist asks for an elevation of each exterior wall showing this, with a legible copy of each approval.
- Check bedroom egress. Each sleeping room needs one openable escape window: at least 5.7 sq ft clear (5 sq ft at grade), 24 inches clear height, 20 inches clear width, and a sill no higher than 44 inches.
- Apply on iBuild. All City of Miami permits are filed online at apps.miamigov.com/iBuildPortal. Plans are reviewed in ProjectDox, and signed-and-sealed documents must carry a digital signature. Window replacement is not on the city's Easy Permit list, so expect document review.
- Record a Notice of Commencement. Florida law (s. 713.13) requires the owner to record one before work starts, unless the job falls under the small-contract exemption in s. 713.02(5).
- Schedule inspections. The city requires inspections for all phases of work, scheduled through iBuild. The permit closes when inspections pass.
- Keep your records. After final inspection, a wind mitigation inspection (form OIR-B1-1802) can document your opening protection for insurers.
What to gather before you ask for a written quote
You can send your measurements to SmartWay at (754) 303-7130 for a written quote. One more date to know: the 9th Edition (2026) of the Florida Building Code is scheduled to take effect December 31, 2026, and permit applications are reviewed under the edition in force when they are filed.
- Your building type and height: house, townhouse, or a floor number in a tower (above 30 feet changes the missile test).
- Whether the building is a threshold building, and its age relative to the 30-year milestone or recertification date.
- Your historic district, if any, and any association design standards.
- Your flood zone from the effective FEMA map.
- Width and height of each opening, and which rooms are bedrooms.
- Wall type (concrete/CBS or wood frame), since the NOA sets the anchors.
Miami questions
Is the City of Miami in the High Velocity Hurricane Zone?
What design wind speed is used for a house in Miami?
Does my window need a Miami-Dade NOA, or is a Florida approval enough?
I live in a Brickell condo. What is different for my windows?
Do I need historic approval to replace windows in Morningside or Palm Grove?
Where do I apply for a window permit in the City of Miami?
Sources
- 2023 Florida Building Code, 8th Ed., HVHZ definition and Sections 1620.2, 1626 (Glass Association / Texas Tech handout)
- Charlotte County notice on the 8th Edition Florida Building Code
- Florida Division of Emergency Management, Hurricane Retrofit Guide - Debris Impact Standards
- Miami-Dade County Building - Windows, Shutters, Doors and Security Bars
- Miami-Dade County NOA document (Product Control Section)
- Miami-Dade County - Replace Windows, Mullions or Glass Doors guideline
- City of Miami - Apply for or Manage Building Permits (iBuild)
- City of Miami - Guide to Getting a Permit
- City of Miami - Building FAQs
- City of Miami - Get an Easy Permit
- Florida Statutes s. 713.02 (2025)
- Florida Statutes s. 553.899 (2025)
- Miami-Dade County presentation to the Florida Building Commission, Existing Building Inspection Workgroup (2022)
- U.S. Census Bureau ACS 2024, B25034 Year Structure Built (Census Reporter)
- U.S. Census Bureau ACS 2024, B25035 Median Year Built (Census Reporter)
- U.S. Census Bureau ACS 2024, B25024 Units in Structure (Census Reporter)
- U.S. Census Bureau QuickFacts, Miami city and Miami-Dade County
- Wikipedia - Brickell
- National Weather Service Miami - Hurricane Andrew
- National Weather Service Miami - Hurricane Irma
- FEMA preliminary FIRM panel 12086C0482M (2024)
- City of Miami - Repair or Renovate a Historic Property
- City of Miami Planning - Historic Districts
- City of Miami Historic Preservation - Morningside