Hurricane code · Lauderdale-by-the-Sea · Broward County

Which hurricane code applies to windows in Lauderdale-by-the-Sea?

Lauderdale-by-the-Sea sits in Broward County's High-Velocity Hurricane Zone, so window and door work needs a town permit and a Miami-Dade NOA or Florida Product Approval. Permits run through the Town's Building Division. Windows facing the beach also fall under a sea-turtle tint rule that most Broward cities never mention.

Last checked: November 3, 2026 · General information, not engineering or legal advice. Confirm requirements for your address with the building department.

The rule only a beach town has: tinted glass for sea turtles

Most window guides stop at wind. Here there is a second test, and it comes from the shoreline. The Town's permit sheet for windows, shutters, doors and garage doors calls for tinted glass with a visible light transmittance (VLT) of .45 or less on openings with a line of sight to the beach.

The reason is lighting. The Florida Fish and Wildlife Conservation Commission lists Lauderdale By The Sea among local governments with a sea turtle lighting ordinance, adopted in 2002 and codified in Chapter 30 of the town code.

If a replacement window faces the ocean side, order the tint from the start and say so when you ask for a written quote. Confirm inland-facing openings with the Building Division.

A narrow barrier island, a very old housing stock

The whole town sits on a long, thin barrier island separated from the mainland by the Intracoastal Waterway. Nothing here is far from salt water.

The housing is old. One Census-based source puts the median year built at 1971. Another estimate says roughly 46% of homes date from the 1940s through the 1960s, about 44% between 1970 and 1999, and under 10% in 2000 or later. Both are third-party figures.

HVHZ, the wind number and the code edition

Broward and Miami-Dade together form the Florida Building Code's High-Velocity Hurricane Zone, the strictest wind section of the state code. The town is in Broward, so it is inside it. The zone grew out of the 1994 South Florida Building Code, written after Hurricane Andrew in 1992.

In the HVHZ wind-load section, Broward's design gust for a typical home (Risk Category II) is 170 mph; the other categories are 156, 180 and 185 mph. That was checked in the 2020 edition's text, and secondary sources report the same values for the current one. Miami-Dade's figure for a typical home is 175 mph.

For scale, the National Weather Service logged an 83 mph sustained wind and a 98 mph gust at Pompano Beach, just north of town, in Wilma on October 24, 2005.

Who issues your permit: the Building Division and its contracted reviewer

The Town has no in-house plan desk. Its Building Division page says permit and inspection services come from a contracted firm, CAP Government, Inc., which receives and approves applications and plans electronically. CAP's own vendor profile lists the Town as a client.

The Building Department is at Town Hall, 4501 N Ocean Drive, Lauderdale-By-The-Sea, FL 33308, phone 954-640-4215 on its forms. Town Hall's main line is 954-640-4200, Monday to Friday, 8:30 am to 4:30 pm.

Applications go in online. The Town publishes an Online Building Permit Guide (June 2022) and joined Broward County's ePermits OneStop. Many permits may need County approvals first, so ask early.

What the Town's window sheet requires before it will accept an application
ItemWhat the Town asks for
ApplicationCompleted, signed and notarized
PlanWhere each window, shutter, door and garage door goes
Product approvalNOA for each product, highlighted
Wind loadOne of the listed standards; signed and sealed pressure calculations per the permit guide
MultifamilyA fire department permit
Beach-facing glassTint with VLT of .45 or less

Putting a window permit package together

The order below follows the Town's own documents. The Town can change its forms.

  1. Pick products with an approval. Each window or door needs a current Miami-Dade NOA or a Florida Product Approval. Highlight the line that matches your size, glass and pressure.
  2. Get pressures for each opening. For a house under 30 feet, Broward's Formal Interpretation #24 allows a sealed plan, a sealed worst-case chart, or the Broward fenestration chart based on ASCE 7-22. Taller buildings need a sealed site-specific design.
  3. Draw the plan and note the tint. Mark every opening and flag any that see the beach.
  4. File in the Town portal. Upload the notarized application, the contract with price breakdown by trade and the Property Appraiser folio printout.
  5. Record the Notice of Commencement if required. Florida Statute 713.135 requires a recorded copy before the first inspection when the contract is above the statutory threshold.

Neighborhoods, ZIP codes and the mailing-address trap

A deed that says Pompano Beach or Fort Lauderdale can still sit inside this town. Town Hall carries ZIP 33308, and records for North Ocean Drive, Pine Avenue and Neptune Avenue are filed as Fort Lauderdale 33308. Coral Reef Drive and South Ocean Boulevard appear under Pompano Beach 33062. The mailing city is not the permitting jurisdiction, so check the Town before you call a different building department. The town sits between Fort Lauderdale to the south and Pompano Beach to the north, and each has its own permit office.

Areas of the town and what usually matters there
AreaTypeWhat to check
Sea Ranch Club (4900-5100 block of N Ocean Blvd)Oceanfront condo associations A, B and C; B is listed as 55+Association approval, beach-facing tint, engineer-sealed loads if 30 feet or taller
Terra Mar and Bel-AirAnnexed single-family areasAsk Public Works about flood status; confirm age of the existing windows
Silver ShoresSingle-family, recent new construction in listing dataNewer homes may already carry current-code openings; read the existing NOA labels

Your house's age against the code eras

Because most homes here predate 1994, a typical home has windows built to an older standard, before today's missile-impact and cyclic-pressure tests. Between 1994 and 2002 the South Florida code applied. After 2002 the Florida Building Code applies, with the HVHZ chapters on top in Broward.

The era tells you what you may have. It does not by itself force a replacement. What triggers today's rules is new work: a permit for new windows or doors means the new openings need an approval and the pressures above.

Flood lines: east of El Mar Drive and along the canals

The Town's Flood Hazard and Maps page says properties east of the Coastal Construction Line, generally the east side of El Mar Drive, and those on or near the Intracoastal Waterway or connecting canals are in Special Flood Hazard Areas. Public Works at (954) 640-4232 can confirm a property.

The Town is a Class 7 Community Rating System community, and its floodplain ordinance includes the 50 percent rule for substantially damaged or improved buildings. Impact glass protects against wind and debris. It is not a flood measure.

Condos, towers and association rules

Height here has a history. The Town limited building heights in 1973 to protect its ocean views, and a town newsletter describes a 44-foot cap from that period. A 2017 settlement reportedly allowed two towers up to 15 stories in the annexed North Beach area, per the Sun Sentinel.

Under Broward's Formal Interpretation #24, a building 30 feet or taller needs a signed and sealed site-specific design by a Florida engineer or architect for every retrofit opening. Generic charts are not enough.

Condo associations add their own written approval before filing. Condo buildings of three or more habitable stories also fall under Florida Statute 553.899 milestone inspections, due by December 31 of the year the building turns 30 and every 10 years after. Broward's separate Building Safety Inspection Program, revised effective August 9, 2024, inspects buildings once they turn 25 and every 10 years after; one- and two-family homes are exempt.

Shutters or impact glass: the code allows either

In the HVHZ, openings need impact glazing or an approved covering. Both need a permit and product approval. Shutters must be put up in time, which matters for an owner who is away. A wind mitigation inspection (form OIR-B1-1802) can document opening protection for your insurer.

Lauderdale-by-the-Sea questions

Do I need a permit to replace windows in Lauderdale-by-the-Sea?
Yes. The Town's sheet for windows, shutters, doors and garage doors says an application is not accepted without a notarized application, a plan of the openings and the highlighted Notice of Acceptance for each product.
Is Lauderdale-by-the-Sea in the HVHZ?
Yes. The High-Velocity Hurricane Zone is Broward and Miami-Dade counties, and the town is in Broward. Windows must carry a Miami-Dade NOA or Florida Product Approval.
What wind speed are windows designed for in Lauderdale-by-the-Sea?
For a typical home the Broward HVHZ design gust is 170 mph. Each opening's pressure also depends on roof height, wall zone and size, so use a sealed plan or the Broward fenestration chart.
Can I use shutters instead of impact windows in Lauderdale-by-the-Sea?
Yes, an approved shutter system is an allowed covering in the HVHZ. It needs a permit and product approval like glass.
Does my Lauderdale-by-the-Sea condo need association approval?
Usually yes. Associations commonly want written approval before the permit is filed. A building 30 feet or taller also needs an engineer-sealed design for each opening.
Does the 40-year recertification or milestone inspection affect my windows?
It can. Condo buildings of three or more stories need milestone inspections under Florida Statute 553.899, and Broward's program, which replaced the old 40-year rule, now begins at 25 years for buildings anywhere in the county. Ask your association for the current report.