Hurricane code · Southwest Ranches · Broward County

Which hurricane window code applies to a home in Southwest Ranches?

Southwest Ranches is in Broward County's High-Velocity Hurricane Zone, so replacement windows and doors need a permit and a Miami-Dade NOA or an HVHZ-approved Florida Product Approval. Broward's design wind speed is 170 mph for ordinary homes. The Town's permits run through CAP Government's online portal.

Last checked: November 3, 2026 · General information, not engineering or legal advice. Confirm requirements for your address with the building department.

A ranch town in the HVHZ: why the rules still apply on a big lot

Southwest Ranches does not look like the rest of Broward County. The Town was incorporated on June 6, 2000, after residents voted on March 14, 2000 to form their own town instead of being annexed by Pembroke Pines or Davie. Most lots are one acre or more, and the Town built equestrian trails to support its rural-equestrian lifestyle.

None of that changes the building code. FBC Section 202 defines the High-Velocity Hurricane Zone as Broward and Miami-Dade counties, and Southwest Ranches is in Broward. Some contractor web pages say the Town is outside the HVHZ. They are wrong: the county line decides it, not distance from the coast.

For a window or door, the HVHZ means two things: the product needs a Miami-Dade Notice of Acceptance (NOA) or a Florida Product Approval whose Limits of Use say it is approved for the HVHZ, and the installation needs a Town permit. A long driveway changes neither.

Design wind speed and the impact test your windows must pass

FBC 2023 Section 1620.2 sets the HVHZ design wind velocity for Broward County at 170 mph, 3-second gust, for Risk Category II buildings, the category for ordinary houses. Miami-Dade is 175 mph. The county-wide number applies in Southwest Ranches, which sits inland in far western Broward.

Section 1626.1 is the one that touches windows. It requires glazing to meet the impact test criteria, or to be protected by an external device that meets them. In the HVHZ, testing uses TAS 201 for large-missile impact, TAS 202 for static pressure and TAS 203 for cyclic loading. Ask which approval number covers the exact size you plan to order.

The Town's neighborhoods and what they share

Five former census-designated places are now neighborhoods of Southwest Ranches, and Landmark Ranch Estates and Sterling Ranch Estates are named communities too. Our research did not confirm construction years or flood zones neighborhood by neighborhood, so the table shows only what applies Town-wide.

Southwest Ranches neighborhoods and the rules that apply
NeighborhoodPreviouslyWindow and door rules
Country EstatesCensus-designated placeHVHZ product approval and Town permit
Green MeadowCensus-designated placeHVHZ product approval and Town permit
Ivanhoe EstatesCensus-designated placeHVHZ product approval and Town permit
Rolling OaksCensus-designated placeHVHZ product approval and Town permit
Sunshine RanchesCensus-designated placeHVHZ product approval and Town permit
Landmark Ranch EstatesNamed communityHVHZ product approval and Town permit
Sterling Ranch EstatesNamed communityHVHZ product approval and Town permit

Permits: Southwest Ranches uses an outside contractor and an online portal

The Town's Building Permitting and Inspections page states that permit and inspection services are provided by an outside contractor, CAP Government, Inc. Applications and plans go through the CAP On-Line Building Permit Portal, and you register an account before submitting.

Inspections are different. In Southwest Ranches they are requested by email to SWRInspections@southwestranches.org, not through the portal. Permit questions go to that same address, or to CAP Government at 954-434-0008, Option 1. Town Hall is at 13400 Griffin Road, Southwest Ranches, FL 33330-2628, and the Town lists (954) 434-0008 as its phone.

The Town posts submittal checklists for new homes, additions, detached ancillary buildings, fences and walls, and pool decks. We found none written only for windows and doors, so confirm the document list with CAP Government before you apply. We also could not confirm the Town's owner-builder rule.

  1. Get the approval numbers. Pick products with an NOA or a Florida Product Approval that lists the HVHZ in its Limits of Use. Check the record on floridabuilding.org.
  2. Build the retrofit schedule. Every window and door retrofit permit in Broward must include the Broward County Uniform Retrofit Window and Door Schedule (BORA Policy 20-01). It lists each opening's ID, approval number, pressure rating, required design pressure, size, wind zone, impact glazing, shutters and mullions.
  3. Register and submit online. Create an account on the CAP On-Line Building Permit Portal linked from the Town's permitting page and upload the plans and schedule.
  4. Record the Notice of Commencement if required. Florida requires a recorded Notice of Commencement before the first inspection when the direct contract is above the state threshold (s. 713.135, F.S.).
  5. Request inspections by email. Send each inspection request to SWRInspections@southwestranches.org.

How design pressure is shown for a one- or two-story ranch house

Most homes here are single-family houses, the case Broward Board of Rules and Appeals Formal Interpretation #24 was written for. It covers retrofit of windows, doors, garage doors and shutters on detached one- and two-family homes and townhouses with a roof height under 30 feet, and was revised on January 9, 2025.

Design pressure for each opening can be shown by a signed and sealed site-specific plan, by an unsealed site plan with a sealed worst-case chart, or by an unsealed site plan using the Broward County Fenestration Voluntary Wind Load Chart (ASCE 7-22). A building at 30 feet or higher is outside the chart and needs a sealed design from a Florida engineer or architect.

Housing age: a median build year of 1982 and what that means for your windows

City-Stats, citing 2023 American Community Survey data, reports a median year built of 1982 and 2,311 housing units. Another ACS-based source puts 36.0% of housing at 1970 to 1999 and 14.0% at 2000 to 2009. The Census Bureau lists the owner-occupied rate at 96.4% for 2019 to 2023. These are Town-wide aggregator figures, not a count for your street.

A house near the median predates the stronger Florida code that followed Hurricane Andrew in 1992, so its original windows were probably not tested to today's HVHZ large-missile standard. A 2000s house was built under the Florida Building Code, but products and test rules have changed since. Check your own address's permit history and the NOA label in the frame.

Flood zones and drainage in a low-lying ranch town

A September 2022 FEMA public notice for a parking-lot project at Town Hall places that site in Zone AH, a 1% annual-chance flood area. The Town adopted its own floodplain regulations in Ordinance 2001-02. Its Public Works and Engineering page links an interactive floodplain map, elevation certificates and the FEMA Flood Map Service Center, and the Town Engineer can answer flood-risk questions.

In a flood hazard area, FBC Section 1612 is added to the HVHZ provisions.

Windows, shutters and documenting your protection

The HVHZ rule allows glazing that passes the impact criteria or glazing covered by an external protection device that meets them. Shutters can be a legal route if they carry their own HVHZ approval and are installed as approved. Impact glass is the other route.

A wind mitigation inspection, form OIR-B1-1802, can document opening protection for your insurer. Ask your insurer what it needs.

Associations, condos and inspection programs

We could not confirm how many properties here sit under a homeowners association, so check your deed and covenants. If yours has one, get its written approval first; the Town permit does not replace it.

Condo milestone rules rarely come up here. Florida's milestone law, s. 553.899, covers condo and co-op buildings of three or more stories, not houses of three or fewer stories, and Broward's Building Safety Inspection Program exempts one- and two-family dwellings.

Southwest Ranches questions

Is Southwest Ranches in the HVHZ?
Yes. FBC Section 202 defines the High-Velocity Hurricane Zone as Broward and Miami-Dade counties, and Southwest Ranches is in Broward. Some contractor pages say otherwise, but the county, not the distance from the coast, decides it.
Do I need a permit to replace windows in Southwest Ranches?
Yes. Window and door replacement is permitted through the Town, whose permit services are run by CAP Government, Inc. You apply on the CAP online portal and request inspections by email to SWRInspections@southwestranches.org.
What wind speed are windows designed for in Southwest Ranches?
Broward County's HVHZ design wind velocity is 170 mph, 3-second gust, for Risk Category II buildings such as ordinary homes. The actual pressure on each opening depends on its size, wall zone and roof height.
Can I use shutters instead of impact windows in Southwest Ranches?
The HVHZ allows glazing that passes the impact criteria or is protected by an external device that meets them. A shutter needs its own HVHZ approval and must be installed as approved. Confirm the approval number with the permit office.
Does my Southwest Ranches home need an NOA or a Florida Product Approval?
It needs one or the other, and the Limits of Use must say it is approved for the HVHZ. Not every Florida Product Approval qualifies. The floridabuilding.org record shows which ones do.
Does a 40-year recertification apply to my Southwest Ranches house?
Probably not. Broward's Building Safety Inspection Program exempts one- and two-family dwellings. Florida's milestone law covers condo and co-op buildings of three or more stories, not houses of three or fewer stories.