Hurricane code · Tamarac · Broward County

Which hurricane code applies to windows in Tamarac?

Tamarac is inside Broward County's High-Velocity Hurricane Zone, so replacement windows and doors need a city permit and a Miami-Dade NOA or Florida Product Approval for each opening. Permits are filed online with the Tamarac Building Department. The code design wind speed for typical homes is 170 mph, and your HOA must approve the work separately.

Last checked: November 3, 2026 · General information, not engineering or legal advice. Confirm requirements for your address with the building department.

A city planned for retirees, and what that means for your windows

Tamarac did not grow around an old downtown. The city's own history page says it was incorporated on July 19, 1963, and that developer Ken Behring bought the land to create an active adult community of two-bedroom, maintenance-free homes. The Tamarac Historical Society describes it as incorporated while still raw land.

That origin shapes the window question today. Behring's first development east of State Road 7 was Tamarac Lakes Sections One and Two. Tamarac Lakes South came next, then the Mainlands of Tamarac Lakes just west of State Road 7, and finally the Woodlands.

The Census Bureau's 2023 estimate puts the city at 72,372 residents. Aggregated Census survey data reports a median year built of 1981 across 34,143 housing units. That means half the homes were built before 1981, well before today's wind-borne debris rules existed.

Is Tamarac in the HVHZ? Yes, and here is the wind speed

Broward and Miami-Dade counties together form the Florida Building Code's High-Velocity Hurricane Zone, the strictest wind section of the state code. Tamarac is in Broward, so it is in the HVHZ even though it sits inland, away from the coast.

The code now in force is the Florida Building Code, 8th Edition (2023), effective December 31, 2023. The Florida Building Commission lists no later edition as in effect.

In the High-Velocity Hurricane Zone the code does not leave the number to a map reading. Section 1620.2 of the 2023 Florida Building Code sets 170 mph (3-second gust) for Risk Category II buildings anywhere in Broward County, so inland Tamarac uses the same figure as the beach. The exact design pressure for each opening is then set for your site by an engineer or the building department.

Miami-Dade NOA or Florida Product Approval for a Tamarac window

Every product in an HVHZ wall must carry an approval number the building department can look up. Tamarac's Windows/Doors/Shutters checklist asks for a floor plan with numbered openings and product approvals for the windows, doors and mullions.

Broward Formal Interpretation #24 lets a Florida engineer or architect modify the buck or the fasteners listed in an approval, as long as the change is documented in a signed and sealed letter or drawing.

Tamarac communities and what to check in each

The city's own history names the communities below. Tamarac uses ZIP codes 33319 and 33321, and City Hall and the Building Department are in 33321.

Tamarac communities from the city's development history
CommunityWhereWhat to check
Tamarac Lakes Sections One and TwoEast of State Road 7The first Behring development, started in 1963. Expect original-era openings; ask for product approvals on any replacement.
Tamarac Lakes SouthBuilt after Sections One and TwoLater phase of the same early development; confirm the age of your windows from the permit record.
Mainlands of Tamarac LakesJust west of State Road 7Developed after Tamarac Lakes South. Ask your association about its window rules before you order.
The WoodlandsLast of the original developmentsCheck association rules and whether your building has three or more stories.
Woodland LakesZIP 33321Same permit office and the same online process as the rest of the city.

The Tamarac Building Department: how a window permit works here

The City of Tamarac Building Department is at 6011 Nob Hill Road, 1st Floor, Tamarac, FL 33321. The main line is 954-597-3420, and permit questions go to Permit@Tamarac.gov. The city's SB 180 recovery guidance lists window and door replacement among the work that needs a building permit.

The city's FAQ says permit applications are submitted online. All permits run through the ePermits system, called the City of Tamarac Building Permits & Inspections Portal, at e-gov.tamarac.org/Click2GovBP. The city points applicants to tamarac.org/building as the starting place, and the system includes an applicant guide and a Fast Trac option.

  • Review time: the city's FAQ says about 5 to 10 business days for minor projects and up to 30 days for larger ones.
  • Building Code violations go to 954-597-3424. Fire Code violations go to the Fire Department at 954-597-3800.
  • Owner-builders: Tamarac has its own Owner-Builder Affidavit, tied to the exemption in Florida Statute 489.103. Ask the Building Department whether your property qualifies before you plan to do the work yourself.
  1. Confirm the contractor is registered. A contractor must be registered with the City of Tamarac before applying for a permit online. Ask to see the registration before you sign anything.
  2. Prepare the opening list. Use the city's Windows/Doors/Shutters checklist: a floor plan with numbered openings, plus product approvals for windows, doors and mullions.
  3. Document design pressure. Broward's Uniform Retrofit Window & Door Schedule lists each opening's approval number, listed and required pressures, size, wall zone, and whether it is impact glass or has shutters.
  4. Record the Notice of Commencement if required. Florida requires a recorded Notice of Commencement above a contract-price threshold. A recorded copy is typically submitted with the application or kept on site for the first inspection.
  5. Schedule inspections. Inspections can be booked through the online portal. The city's phone scheduling system needs the permit's PIN or phone access code.

Design pressure: homes under 30 feet versus condo buildings above it

Broward Formal Interpretation #24 covers retrofit of windows, doors, garage doors and shutters on detached one- and two-family homes and townhouses with a roof height under 30 feet. For each opening, the design pressure comes from one of three routes: a signed-and-sealed site-specific plan, an unsealed plan with a sealed worst-case pressure chart, or an unsealed plan using the Broward County Fenestration Voluntary Wind Load Chart.

The current chart is based on ASCE 7-22. It gives wall pressures by mean roof height (15, 20, 25 and 30 feet), wall zone and tributary area. Zone 4 is the field of the wall and zone 5 is near corners, which is why corner windows face higher pressure than middle ones.

Above 30 feet of mean roof height, the generic chart is not accepted. A Florida engineer or architect must sign and seal site-specific wind loads. That matters for Tamarac's multi-story condominium buildings.

Your Tamarac home's age against the code eras

With a median year built of 1981, the typical Tamarac home predates the stricter South Florida Building Code rules that arrived in the 1990s. Renter-occupied stock is concentrated in the 1970s and 1980s, with 3,012 units built between 1970 and 1979 and 2,230 between 1980 and 1989, according to Census survey data compiled by a real-estate site.

  • Built before 1994: likely original windows or older aluminum units with no impact rating. A replacement needs a permit and an approved product.
  • Built 1994 to 2002: designed under the South Florida Building Code. Check whether your openings carry impact glass or shutters, and look for a product label or old permit.
  • Built after 2002: built under the Florida Building Code. Your windows may already carry a product approval; check the permit record before assuming.
  • Not sure of the era? Ask the Building Department for your permit history, then compare it with the product approval on any window you plan to keep.

HOA approval, condo milestones and the 25-year program

The city is blunt about this: a Tamarac building permit does not guarantee your homeowners' association allows the work. You get association approval separately, and you should have it in writing before you order.

For condo and co-op buildings of three or more habitable stories, Florida Statute 553.899 requires a milestone inspection by December 31 of the year the building turns 30, then every 10 years. The local building official may move that to 25 years based on conditions such as proximity to salt water.

Broward's Building Safety Inspection Program (BORA Policy 05-05) applies to buildings 25 years or older, with re-inspection every 10 years. Owners get a notice between June 1 and August 31 and have 180 days to file a structural and electrical report, then 180 days to finish repairs. One- to four-family dwellings of three or fewer stories, fee-simple townhouses and buildings under 3,500 square feet are exempt. This description comes from Pompano Beach's published summary, and Tamarac's own enforcement page was not confirmed.

Shutters or impact windows in Tamarac

The Broward Retrofit Schedule works opening by opening. For each one it records whether the glass is impact glass, whether shutters already exist, and whether new shutters or mullion tubes are required. So the code answer is that each opening needs protection, either impact glazing or a shutter with an approval, and the form shows which you chose.

Whichever you pick, it must match an approved product at the right pressure. If you want a quote for windows made to order, send your measurements and openings list to SmartWay at (754) 303-7130 so the quote can be matched to your checklist.

Tamarac questions

Do I need a permit to replace windows in Tamarac?
Yes. The city's SB 180 recovery guidance lists window and door replacement among the work that requires a building permit. Applications are submitted online through the city's ePermits system, and a contractor must be registered with the City of Tamarac first.
Is Tamarac in the HVHZ?
Yes. Tamarac is in Broward County, which with Miami-Dade forms the Florida Building Code's High-Velocity Hurricane Zone. Being inland does not change that. Products need a Miami-Dade NOA or a Florida Product Approval that covers the pressure at each opening.
What wind speed are windows designed for in Tamarac?
Section 1620.2 of the 2023 Florida Building Code sets 170 mph (3-second gust) for Risk Category II buildings in Broward County, and Tamarac uses that figure even though it is inland. The exact pressure for each opening comes from an engineer, the building department or the Broward wind load chart.
Can I use shutters instead of impact windows in Tamarac?
The Broward Retrofit Schedule records, per opening, whether the glass is impact glass or whether shutters with an approval are used. Either route can be documented, but the shutter or window must have an approval number that matches the pressure for that opening.
Does my Tamarac condo or HOA need to approve new windows?
Yes, separately from the city. The city states that a Tamarac permit does not guarantee your association allows the work. Get written association approval first. For condo towers over 30 feet, sealed site-specific wind loads are also needed.
How does the 40-year or 25-year recertification affect windows in Tamarac?
Broward's Building Safety Inspection Program applies to buildings 25 years or older, with re-inspection every 10 years. Florida's milestone rule covers condo buildings of three or more stories at 30 years, or 25 if the local official sets it. Reports can flag openings that need repair.