Hurricane code · Hallandale Beach · Broward County

Which hurricane code applies to windows in Hallandale Beach?

Hallandale Beach is inside the High-Velocity Hurricane Zone, so replacement windows and doors need a permit and an approved product, either a Miami-Dade Notice of Acceptance or a Florida Product Approval. Broward's design wind speed is 170 mph for ordinary buildings. The city's Building Division, at City Hall, handles the permit.

Last checked: November 3, 2026 · General information, not engineering or legal advice. Confirm requirements for your address with the building department.

A small, dense city with towers on one side and older streets on the other

Hallandale Beach had 41,217 residents in the 2020 Census on about 4.21 square miles of land. That works out to roughly 9,786 people per square mile, which makes it one of the most densely settled cities in Broward County.

Because the city is so compact, one window code covers very different buildings. Oceanfront towers on South Ocean Drive, canal-side homes in Golden Isles and single-family streets west of US-1 all fall under the same county-wide hurricane rules. What changes from street to street is the building height, the age of the structure and who has to approve the work.

The city was incorporated as a town on May 14, 1927 and took the name Hallandale Beach in 1999.

Is Hallandale Beach in the HVHZ, and what wind speed does the code use?

Yes. Broward and Miami-Dade counties together make up the High-Velocity Hurricane Zone (HVHZ) in the Florida Building Code, and Hallandale Beach is in Broward. Buildings in the HVHZ follow the wind-load rules of FBC Section 1620.

The edition now in effect is the Florida Building Code, 8th Edition (2023), which took effect on December 31, 2023. Section 1620.2 sets Broward's design wind speed, as a 3-second gust, at 170 mph for Risk Category II buildings. That category covers most homes and apartment buildings. Category I is 156 mph, Category III is 180 mph and Category IV is 185 mph.

In practice the number on your permit comes from the opening's required design pressure, not from one headline speed. The window you pick has to be tested to at least the pressure required for its location on the building.

Product approval: Notice of Acceptance or Florida Product Approval

A window or door in the HVHZ must carry proof that it passed the large-missile impact and pressure tests. Two kinds of proof are accepted: a Miami-Dade Notice of Acceptance (NOA) or a Florida Product Approval. The approval number goes on your permit paperwork next to the opening it covers.

An alliance summary of Hallandale Beach permit items lists windows, doors, louvers and shutters among the products that need a Notice of Acceptance with the submission. It also warns that the information can change, so confirm with the city before you order anything.

  • Match the approval number to the exact size, glass and frame on your order.
  • Shutters need an approval too. They are not exempt.

What applies on the streets of ZIP 33009

Addresses in the city use ZIP code 33009. The table below sorts the streets we could confirm by what they tend to mean for a window project. It describes setting and era, not a ruling on any one address.

Hallandale Beach areas and what they mean for window work (ZIP 33009)
Area or streetSettingWhat it means for windows
South Ocean Drive (e.g., 1850, 1880, 3180 S. Ocean Dr.)Oceanfront towersTall buildings: check the 30-foot roof-height rule and the condo milestone rules. Beachfront lighting rules also apply.
Golden Isles DriveDredged canals and man-made islands from the 1950sWaterfront homes date from that era onward, so original openings likely predate modern impact standards.
Three Islands Blvd, Paradise Isle Blvd, Layne BlvdResidential streets with listed buildingsMix of building types. Height and ownership decide the permit path.
Diana Drive, Parkview DriveResidential streetsConfirm building type and association rules first.
SW 5th Avenue, NW 6th Court (west of US-1)Single-family streetsHouse-type retrofit path under the Broward interpretation, described below.

The 30-foot rule that matters for the oceanfront towers

Broward publishes a fenestration wind-load chart based on ASCE 7-22. It gives wall pressures by mean roof height, wall zone and opening size. Zone 4 is the field of the wall and Zone 5 is the area near corners.

The chart only covers mean roof heights of 15, 20, 25 and 30 feet. Under Broward Board of Rules and Appeals Formal Interpretation #24, a building with a mean roof height over 30 feet needs site-specific design wind loads, signed and sealed by a Florida engineer or architect.

For a house in Hallandale Beach, the generic chart is usually enough. For a high-rise condo on South Ocean Drive, it is not. An owner replacing a sliding door on a high floor should expect the association or its engineer to supply the pressures for that building.

Where the permit goes: Hallandale Beach Building Division

The Building Division sits inside the city's Department of Sustainable Development. It is at City Hall, 400 S. Federal Highway, Hallandale Beach, FL 33009.

The Building Division's phone is 954-457-1386, per Broward County's ePermits contact page. The city's main line is 954-458-3251.

  1. Pick a way to submit. Two secondary sources describe the HB Self-Service Portal for electronic applications, fee payment and inspection scheduling. They also describe Broward ePermitsOneStop, where city and county staff review at the same time, and in-person filing at City Hall. We could not confirm the portal address, so find it through the city's Permit Process Information page.
  2. Use the city's own forms. The city's Applications and Forms page lists the Building Permit Application, the Broward Retrofit Window and Door Schedule and the Broward Fenestration Voluntary Wind Load Chart.
  3. Fill in the retrofit schedule. The schedule is a Broward form that lists each opening's ID, product approval number, tested and required design pressures and anchoring. The tested pressure must meet or exceed the required one.
  4. Sign and seal correctly. The city states that digitally signed and sealed documents need third-party verification. Plans are rejected if the signature cannot be verified.
  5. Record a Notice of Commencement when the job is large enough. Broward cities require a recorded Notice of Commencement once the contract passes the Florida lien-law threshold. Ask the city whether your job crosses it.

Housing age against the code eras

Property-record data for roughly 25,000 Hallandale Beach properties puts the median year built at 1973. A census-tract grouping that includes Pembroke Park and Hallandale Beach shows 1970. Neither is an official ACS figure.

Even so, they point the same way: most of the city's buildings went up before South Florida's 1994 amendments to its building code, and well before the statewide Florida Building Code that began in the early 2000s. In general terms, that gives you three groups.

  • Built before 1994: likely original windows with no tested impact rating. Expect the biggest change on replacement.
  • Built between 1994 and the early 2000s: some openings may have been built to the South Florida code, which already required protection in this zone. Check what the permit file shows.
  • Built under the Florida Building Code: openings should already carry an approval number. Look for it on the frame or in the paperwork before assuming anything.

Condos, milestone inspections and why associations are watching the envelope

Florida Statute 553.899 requires a milestone structural inspection for condominium and cooperative buildings of three or more habitable stories. It is due by December 31 of the year the building turns 30, counted from its certificate of occupancy, and then every 10 years.

Broward's own Building Safety Inspection Program, in Section 110.15 of the Board of Rules and Appeals rules, follows BORA Policy 05-05, revised effective August 9, 2024. It calls for a structural and electrical inspection once a building reaches 25 years, with re-inspection every 10 years. That clock is countywide, so it reaches every Hallandale Beach tower, not only those near the water.

Hallandale Beach's mayor told residents in 2022 that condominiums of three or more stories are subject to milestone inspections, done by an architect or structural engineer. In April 2026 the mayor also reported a structural failure of a portico at 1250 East Hallandale Beach Boulevard. Only the walkway cover was affected, and the building and garage stayed safe.

We could not confirm whether the city asks for an association approval letter with a window permit. Ask your board before you order.

A city program most owners do not know about

The City of Hallandale Beach has a Hurricane Shutter and Impact Glass Program with its own application. The form asks for two estimates and color pictures of the windows or doors. Installation must be finished and inspected by the Building Division within 120 days of approval, and an application fee applies.

We do not know who qualifies or how much help the program offers, because the form does not say in the part we could read. Contact the city if you want to ask whether it is open to you.

Beachfront glass and the sea turtle lighting rule

Hallandale Beach is one of the coastal governments with a sea-turtle lighting ordinance, adopted in 2001 as Chapter 6, Article I of the city code. The state model rule controls light that escapes through glass windows and doors on the seaward side of beachfront buildings.

If your unit faces the Atlantic, the glass you choose may be looked at for both hurricane rating and light. Ask the city which tint or treatment it accepts before ordering.

Shutters or impact glass?

Both routes can satisfy the code, as long as the product has an approval and the permit lists it. Shutters must be installed and removed each season, and they must be tested for the pressures on your openings. Impact glass stays in place and works all year.

The submission is the same either way: permit application, approval numbers, and a schedule of pressures. Wilma in October 2005 brought widespread structural damage to Broward County, and Irma in September 2017 brought hurricane-force gusts to the county's coastal stations.

How SmartWay can help you prepare

SmartWay helps you build your configuration and request pricing from your own measurements. Send your measurements and the building type (house, or condo above or below 30 feet), and ask for a written quote. Then take the approval numbers to the Building Division with your application.

Hallandale Beach questions

Do I need a permit to replace windows in Hallandale Beach?
Yes, replacing windows and doors is work the city permits. Applications go to the Building Division in the Department of Sustainable Development, with a product approval for each opening. Confirm the current steps on the city's Permit Process Information page before you start.
Is Hallandale Beach in the HVHZ?
Yes. It is in Broward County, which with Miami-Dade forms the High-Velocity Hurricane Zone. Products need a Miami-Dade Notice of Acceptance or Florida Product Approval, and wind loads follow FBC Section 1620.
What wind speed are windows designed for in Hallandale Beach?
The 2023 Florida Building Code lists 170 mph as Broward's design gust for Risk Category II buildings, which includes most homes and condos. Your required pressure for each opening depends on height, wall zone and size, and it goes on the retrofit schedule.
Can I use shutters instead of impact windows in Hallandale Beach?
Yes, if the shutters are an approved product and the permit lists them. The same approval and wind-pressure paperwork applies. The difference is that shutters must be put up before each storm.
Does my Hallandale Beach condo need association approval for new windows?
Check your documents. We could not confirm a city rule requiring an approval letter, but many associations require their own sign-off, and buildings over 30 feet need engineer-sealed wind loads. Ask your board or manager before you order.
How do the 40-year recertification and milestone inspection affect my windows?
They look at the building's structure, not only the glass. Florida's milestone rule applies at 30 years for condos of three or more stories. Broward's program, which replaced the old 40-year rule, applies at 25 years countywide. Failing openings can be named in a report, so ask your association for its inspection findings.