Hurricane code · Miramar · Broward County

Which hurricane code applies to windows in Miramar, Florida?

Miramar is in Broward County's High-Velocity Hurricane Zone, so windows and doors need an approval valid for HVHZ use, and the design gust is 170 mph for ordinary houses. Permits go through the City of Miramar Building Division at 2200 Civic Center Place and its online portal, with HOA approval handled separately.

Last checked: November 3, 2026 · General information, not engineering or legal advice. Confirm requirements for your address with the building department.

Miramar is an inland city built mostly in the 1990s, and that shapes the window question

Most hurricane window pages for Broward start at the beach. Miramar has no beach. It sits inland, was incorporated on May 26, 1955 with fewer than 200 people, and grew as a bedroom community for Fort Lauderdale and Miami. Today it has 134,721 residents (2020 census), which makes it the fourth-largest city in Broward County.

The housing is young for South Florida. The Census Bureau's 2023 American Community Survey puts the median year a Miramar home was built at 1996, across 46,258 housing units. Half the homes are older than that, half are newer. That single number tells you which code era your windows probably came from, and we use it below.

Being inland changes some rules and not others. The wind code does not care that you are miles from the water. The coastal condo inspection trigger does. Both are covered in this page.

The code that applies: Broward's High-Velocity Hurricane Zone

The Florida Building Code defines the High-Velocity Hurricane Zone (HVHZ) as Broward and Dade counties. Miramar is in Broward, so it is in the HVHZ. Some contractor pages say otherwise or call the zone coastal only. The code text does not make that distinction. If you read a different answer elsewhere, check Section 202 of the Florida Building Code.

For wind speed, FBC 2023 Section 1620.2 sets the Broward design gust at 170 mph for ordinary houses (Risk Category II). Miami-Dade County, just south of Miramar across the county line, uses 175 mph for the same category. A few miles can change the number on the plans.

Section 1626.1 requires glazing in the building envelope to pass the impact tests or be covered by an external protection device that passes them. The large-missile test applies to openings up to and including 30 feet in height. That is why the choice in Miramar is impact glass or approved shutters, not plain glass.

What the label on the window has to say

In the HVHZ, the product needs an approval that is valid for HVHZ use. A Miami-Dade Notice of Acceptance (NOA) is evaluated to the HVHZ standards. A Florida Product Approval may or may not be: its evaluation report lists "Approved for use in HVHZ: Yes" or "No" under Limits of Use.

So before you accept a quote, ask for the approval number and read the HVHZ line yourself. Then match the tested size and pressure rating to each opening in your home.

Florida's current code is the 8th Edition (2023), effective statewide on December 31, 2023. The City of Miramar states that it went into effect January 1, 2024 for permit applications, and that applications received before that date were reviewed under the 7th Edition (2020).

Miramar's own permit office and portal

Window and door permits go through the City of Miramar Building Division, part of the Building, Planning & Zoning Department. The office is at 2200 Civic Center Place, Miramar, FL 33025, and the Building Division phone is 954.602.3200. An older city guide lists a different address and number; those are out of date.

Applications are filed online through the city's Citizen Self Service portal at mss.miramarfl.gov, which is open around the clock. The city also offers over-the-counter help Monday through Thursday, 7:00 AM to 5:00 PM, until further notice. After the permit is issued, the inspections page lists the Building Division at 954-602-3200, Fire Prevention at 954-602-4882 and Engineering Inspections at 954-602-3304.

  • Doors & Windows package for FBC 2023, revised December 2024, on the city's Applications & Forms page.
  • A separate Shutters package, also revised December 2024.
  • The Broward Fenestration Voluntary Wind Load Chart and the Broward Uniform Retrofit Window & Door Schedule, hosted by the city.
  • A Homeowner's Association Affidavit of Awareness and a Construction Debris Removal Affidavit in the residential packages, which the city describes as mandatory under its ordinances.

What a Miramar window submittal looks like

The city's Doors & Windows package asks for a floor-plan sketch that shows the location and size of every proposed door and window. Each opening is labeled to match the Broward Uniform Retrofit Window & Door Schedule.

That schedule (BORA Policy 20-01, effective July 1, 2020) lists, for each opening, its ID, the product approval number, the listed and required design pressures in psf, the size in inches, the area, the wall zone (4 or 5), whether the glazing is impact, any existing shutters, and whether new shutters or mullion tubes are needed.

Many Miramar homes are single-family houses or townhomes under 30 feet. For those, Broward Formal Interpretation #24 (approved October 12, 2023; memo dated January 9, 2025) lets the design pressure come from one of three routes: a sealed site-specific plan, an unsealed plan with a sealed worst-case pressure chart, or an unsealed plan using the Broward wind load chart based on ASCE 7-22. The chart gives wall pressures by mean roof height (15, 20, 25 and 30 feet), wall zone and tributary area.

At 30 feet or taller, a Florida engineer or architect must sign and seal a design that shows every opening and its pressure. A generic chart alone is not accepted. A Florida engineer or architect can also modify the buck or fasteners listed in an NOA, with a signed and sealed letter or drawing.

Doing it yourself in Miramar

Miramar's Owner/Builder Disclosure Statement follows Florida Statute 489.103. The owner acknowledges that state law generally requires a contractor for this work and accepts personal liability for it. A homeowner-builder applicant appears in person with picture ID that matches the job address and proof of ownership, such as a recorded warranty deed. The Permit Clerk at the Building Division can notarize the affidavit.

Whether a recorded Notice of Commencement is needed at Miramar's own threshold is not something we confirmed. Ask the Building Division. Other Broward cities set it at contract values over a figure stated in their checklists, and Miramar may differ.

Miramar by ZIP code and community

Miramar uses four ZIP codes: 33023, 33025, 33027 and 33029. The table lists the named communities we could place, and what each one means for windows. We could not confirm build years for individual communities, so the table does not guess them.

Miramar areas and what to check
AreaZIPWhat we knowWindow angle
Miramar Isles, Miramar Park33023Older neighborhoods in eastern MiramarLikely older openings; confirm the era and any existing shutters
City Hall area (Building Division)330252200 Civic Center Place is in this ZIPWhere permits are handled, not a separate code
Sunset LakesMiramarGated, single-family and townhome, master HOA with subdivisions Grand Isle and MonacoCheck master and subdivision HOA rules
Riviera IslesMiramarGated HOA communityHOA approval before ordering
Monarch LakesMiramarGated, HOA-managed subdivisions in central MiramarAsk the association what exterior changes need approval
Vizcaya, NauticaMiramarGated townhome communitiesTownhome rules and shared exteriors may apply
Silver Lakes, Silver Isles, Silver Shores, Silver Falls33029Silver Lakes is a gated community in western MiramarCheck the HOA and confirm the roof height

Your house's age against the code eras

Use the 1996 median as a starting point, not a verdict. A home built before the 1994 South Florida Building Code amendments may have no tested impact protection at all. A home between 1994 and 2002 may have protection tested to the standards of that period. A home built after the 2002 Florida Building Code was designed under the statewide code.

We did not find a Miramar-specific count of homes built before 1994, so we cannot say what share of the city falls in each era. Your own permit history is the better guide. The Building Division can tell you what was approved for your address.

Replacing windows in an older house does not change the pressure the wall has to resist. It does mean the old frames, bucks and fasteners need a look, which is why the Broward retrofit schedule exists.

Shutters or impact windows

The code allows impact glazing or an approved external protection device. Miramar publishes a Shutters package that is separate from its Doors & Windows package, so shutters get their own permit paperwork.

The practical difference is when the protection is in place. Shutters work only when someone has closed them. Impact glass is in place the whole time. Either route has to carry an approval valid for the HVHZ and be matched to the pressure for each opening.

HOA, condos and flood zones in Miramar

Many Miramar neighborhoods are gated with a master HOA. Miramar's residential permit packages include a Homeowner's Association Affidavit of Awareness, so raise the association question before you order, not after. HOA approval is separate from the city permit, and a city permit does not override it.

For condominiums, Florida Statute 553.899 requires milestone inspections of condo and co-op buildings three or more stories tall by December 31 of the year the building turns 30, then every 10 years. A local agency may use 25 years for conditions such as nearness to salt water. Broward's own Building Safety Inspection Program is a separate rule. Under BORA Policy 05-05, revised effective August 9, 2024, it requires structural and electrical inspection once a building is 25 years old, then every 10 years. It applies across the county, so being inland does not exempt Miramar buildings.

On flood, keep it separate from wind. The city's Floodplain Management page lets you search an address for its flood zone and FEMA Base Flood Elevation, and the city participates in FEMA's Community Rating System. The city's map service cites the April 2014 Flood Insurance Rate Map and says it reflects 2024 FEMA flood zone data. Miramar is drafting a Floodplain Management Plan. A flood zone affects insurance and elevation rules, not which window you need.

What past storms showed

Hurricane Wilma crossed Broward County on October 24, 2005. The National Weather Service recorded a 99 mph peak gust at Fort Lauderdale and reported the heaviest structural damage in Broward and Palm Beach counties. During Irma in 2017, southeast Florida's damage was mostly roof coverings and screened patios.

We found no Miramar-specific wind readings for these storms, so those figures are county and regional. The 170 mph figure is a design number, not a forecast. Wind mitigation inspections (form OIR-B1-1802) can document opening protection for your insurer.

Miramar questions

Do I need a permit to replace windows in Miramar?
Miramar publishes a Doors & Windows permit package and takes applications through its online portal, so plan on a permit. Third-party sites disagree about same-size replacements. Call the Building Division at 954.602.3200 before you start, and do not rely on a contractor's sales page.
Is Miramar in the HVHZ?
Yes. The Florida Building Code defines the High-Velocity Hurricane Zone as Broward and Dade counties, and Miramar is in Broward. Some contractor pages say it is not, but they do not cite the code. Windows need an approval that is valid for HVHZ use.
What wind speed are windows designed for in Miramar?
For ordinary houses (Risk Category II), FBC 2023 Section 1620.2 sets Broward's HVHZ design gust at 170 mph. Miami-Dade, directly south across the county line, uses 175 mph. The pressure on each opening then depends on its size, wall zone and roof height.
Can I use shutters instead of impact windows in Miramar?
Yes. The code accepts impact glazing or an external protection device that passes the impact tests. Miramar has a separate Shutters permit package. Either product needs an approval valid in the HVHZ and must match the pressure for each opening.
Does my Miramar HOA need to approve new windows?
Often yes. Many Miramar communities are gated with a master HOA, and the city's residential permit packages include a Homeowner's Association Affidavit of Awareness. Ask your association what it requires before ordering. A city permit does not replace HOA approval.
Does Miramar have a 40-year recertification for condos?
Florida requires milestone inspections of condo buildings three or more stories at 30 years, then every 10 years. Broward's own program, which replaced the old 40-year rule, begins at 25 years countywide, and that includes inland Miramar. Ask your association which schedule it follows.