Hurricane code · Fort Lauderdale · Broward County

Hurricane window code in Fort Lauderdale: what applies to your home

A Fort Lauderdale home falls under the Florida Building Code's High-Velocity Hurricane Zone, because Broward County is one of its two counties. A typical house is designed for a 170 mph gust, the city asks for a Miami-Dade Notice of Acceptance, and every opening goes on Broward's uniform retrofit schedule.

Last checked: October 24, 2026 · General information, not engineering or legal advice. Confirm requirements for your address with the building department.

Why Fort Lauderdale is a special case

Only two Florida counties are held to High-Velocity Hurricane Zone (HVHZ) rules: Broward and Miami-Dade. Fort Lauderdale is in Broward, so a window here is held to a stricter standard than the same window one county north in Palm Beach.

Three local facts shape what that means for your home. First, the housing is old. The median home in the city was built in 1973. Second, the city is split between houses and towers: about 40% of homes sit in buildings with 20 or more units. Third, water is everywhere. The city has about 165 miles of inland waterways tied to the Intracoastal, and the city says most residents live in or close to a Special Flood Hazard Area.

Each of those facts changes which rules apply to you.

The design wind speed for Broward County

In the HVHZ, wind loads come from Section 1620.2 of the Florida Building Code. Broward has its own fixed values by Risk Category. Most homes are Risk Category II.

These values were verified in the 2020 (7th Edition) code text. Secondary sources report the same Broward values for the current 8th Edition. Miami-Dade's Risk Category II value is higher, at 175 mph.

Broward County design wind velocity, 3-second gust (FBC Section 1620.2)
Risk CategoryTypical useDesign wind speed
ILow-hazard structures156 mph
IITypical homes170 mph
IIIHigher-occupancy buildings180 mph
IVEssential facilities185 mph

How old your home is, and what code it was built under

After Hurricane Andrew in 1992, the 1994 South Florida Building Code created the HVHZ idea. Florida later replaced more than 400 local codes with one statewide code. Fort Lauderdale's housing mostly predates all of that, so many original windows were never tested for wind-borne debris.

A replacement window today must meet the code in force when you apply for the permit, not the code your house was built under.

  • Florida Building Code 8th Edition (2023): in effect since December 31, 2023.
  • Florida Building Code 9th Edition: scheduled for December 31, 2026. Permits applied for after that date may fall under it, so timing your application matters.
Fort Lauderdale housing units by year built (ACS 2024 1-year, B25034)
BuiltShare of housing units
1950 to 1979About 60% (58,621 of 98,308)
Before 1990About 70%
Before 2000About 75%
2000 or laterAbout 25%

Product approval and the Broward retrofit schedule

The City of Fort Lauderdale Windows and Doors Permit Checklist (Rev. 6, 1/30/2024) asks for a copy of the Miami-Dade County Notice of Acceptance (NOA) for each product. You get it from the place you buy the window. The checklist also says windows and doors must be impact resistant unless shutters protect them.

Every application must use the Broward County Uniform Retrofit Window & Door Schedule (BORA Policy 20-01). It lists, for each opening:

  • Where the opening is on the house
  • The product approval number and its approved pressure rating
  • The design pressure that opening requires
  • The size
  • Impact glazing or shutter protection
  • Any mullions

Where the design pressure comes from (BORA F.I. #24)

Broward's Board of Rules and Appeals wrote Formal Interpretation #24 for window, door, garage door and shutter retrofits on detached one- and two-family homes and townhouses with a roof height under 30 feet. It gives three ways to set the design pressure for each opening:

  • F.I. #24 also lets a Florida engineer or architect modify the buck or fasteners listed in an NOA, with a signed and sealed letter or drawing. This often comes up in older block homes where the opening does not match the approval's details.
  1. Sealed site plan. A signed and sealed site-specific plan from a Florida engineer or architect.
  2. Unsealed plan plus sealed chart. An unsealed plan paired with a sealed worst-case pressure chart.
  3. Unsealed plan plus Broward chart. An unsealed plan that uses the Broward County Fenestration Voluntary Wind Load Chart, which is based on ASCE 7-22.

Condos and high-rises along the coast

About 30% of Fort Lauderdale homes are in buildings with 50 or more units. For these, the rules tighten.

Under F.I. #24, a building 30 feet or taller needs a signed and sealed site-specific design from a Florida engineer or architect that shows every retrofit opening and its design pressure. Generic charts are not accepted. The city checklist says the same thing another way: under three stories you may use the ASCE 7 chart; taller buildings need wind pressures from the designer of record.

Wind is not theory here. During Hurricane Wilma in 2005, NWS Miami logged a preliminary peak gust of 99 mph at Fort Lauderdale. News reports described gusts over 100 mph blowing out high-rise windows downtown.

  • Florida Statute 553.899: condo and co-op buildings three or more habitable stories tall need a milestone inspection by December 31 of the year they turn 30, then every 10 years. A local agency may use 25 years near salt water.
  • Broward's Building Safety Inspection Program: under BORA Policy 05-05 as revised August 9, 2024, buildings 25 years or older need structural and electrical safety inspections, then every 10 years. One- and two-family homes and buildings under 3,500 sq ft are exempt.
  • Your association may also set its own window color, frame and glass rules. Ask for them before you choose a product.

Flood zones, surge and the waterfront

Window code is about wind, but location still matters. The city lists inland high-risk flood zones A, AE, AH and AO, and coastal high-hazard VE zones where waves reach. Fort Lauderdale is a Class 7 community in FEMA's Community Rating System.

During Hurricane Irma in 2017, NWS Miami recorded an 87 mph gust at Port Everglades and storm surge slightly over 3 feet along the Broward coast, with beachfront flooding up to Fort Lauderdale. Waterfront homes on the isles and near the beach get both higher exposure and more salt.

Sailboat Bend and the other historic districts

Fort Lauderdale has three locally designated historic districts: Sailboat Bend, Himmarshee St./SW 2nd Ave., and the Stranahan House district. Sailboat Bend is the oldest neighborhood and the largest district, with more than 550 buildings, many of them small one-story homes with Bungalow, Mission or Mediterranean Revival details. It is governed by ULDR Section 47-17, and a 2021 survey marked each property Contributing or Non-Contributing.

Any work that changes the outside look of a designated property needs a Certificate of Appropriateness (COA). A replacement that matches existing features can be reviewed by the Historic Preservation Planner. Other work goes to the monthly Historic Preservation Board. You start at the Urban Design and Planning counter; once approved, the file moves to the Building Division.

Replacing windows in Fort Lauderdale, step by step

  1. Confirm your city. A Fort Lauderdale mailing ZIP does not always mean the City of Fort Lauderdale. Some of those ZIPs reach into other cities. Your permit office is set by the property's actual city.
  2. Check historic and association rules. If the home is in a historic district, get the COA first. If you have an HOA or condo board, get its written approval and specs.
  3. Measure every opening. List each window and door by location and size. This becomes the base of the Broward retrofit schedule.
  4. Set design pressures. Under 30 feet, use one of the three F.I. #24 paths. At 30 feet or taller, an engineer or architect must seal a site-specific design.
  5. Choose products with an NOA. Match each opening to a product whose Miami-Dade NOA covers its size and required pressure. Keep a copy of each NOA.
  6. Apply on LauderBuild. Since January 1, 2024, the city takes no paper applications. Apply at LauderBuild (aca3.accela.com/FTL): sign in, then choose Apply > Permits/Engineering (ROW). Plans go through the LauderBuild Plan Room.
  7. Record the Notice of Commencement. Under Florida Statute 713.135, when the contract is above the statute's threshold, a recorded Notice of Commencement must be filed with the permit office before the first inspection.
  8. Install and schedule inspections. Book the inspections on your permit through DSD Customer Service at 954-828-6520, option 1, Monday to Friday, 8:00 am to 3:30 pm.
  9. Close the permit and document it. After final approval, keep the permit, schedule and NOAs together. A wind mitigation inspection on form OIR-B1-1802 can document your opening protection for insurers.

What drives the cost of a Fort Lauderdale project

This guide does not quote prices. When you compare written quotes, these local factors explain most of the difference:

  • HVHZ products: approvals and testing for Broward are stricter than for non-HVHZ counties.
  • Size and design pressure: large openings and corner zones need higher ratings.
  • Glass makeup: thicker or stiffer laminated glass may be needed for big or high-pressure lites.
  • Door count: sliding doors to pools and docks are usually the largest openings in the house.
  • Engineering: sealed designs for buildings 30 feet or taller, or sealed letters to change bucks and fasteners.
  • Association and historic specs: required colors, frame styles or COA conditions.
  • Often not in a product quote: permit fees, engineering, stucco and drywall repair, and disposal. Ask what is included.

After a storm: the 60-day shutter rule

A city notice cites City Code Section 18-9(a): boarding up openings for an emergency is limited to 60 days. The city has asked owners to take shutters down after a storm, and said plywood strips are not a proper substitute for installed shutters on empty homes. Questions go to Community Enhancement and Compliance at 954-828-5207.

Next step

Send your measurements and the list of openings, and ask for a written quote that names the NOA for each product. Questions: (754) 303-7130.

Fort Lauderdale questions

Is Fort Lauderdale in the High-Velocity Hurricane Zone?
Yes. The Florida Building Code's HVHZ covers only Broward and Miami-Dade counties, and Fort Lauderdale is in Broward. That means HVHZ wind loads from FBC Section 1620.2 apply, with a 170 mph design gust for a typical home (Risk Category II), and the city's checklist asks for a Miami-Dade Notice of Acceptance.
What wind speed do windows need to meet in Fort Lauderdale?
Broward's design wind speed for a typical home is 170 mph (3-second gust, Risk Category II). The window itself is tested and labeled by design pressure, not mph. Each opening's required pressure comes from a sealed plan, a sealed chart or the Broward Fenestration Voluntary Wind Load Chart, and goes on the retrofit schedule.
Do I need an engineer to replace windows in my Fort Lauderdale condo?
If the building is 30 feet or taller, yes. Broward BORA F.I. #24 requires a signed and sealed site-specific design from a Florida engineer or architect showing every retrofit opening and its pressure; generic charts are not accepted. Also get your association's written approval and window specs first.
Can I submit a paper window permit in Fort Lauderdale?
No. Since January 1, 2024, the city accepts new permit applications and plans only through LauderBuild, its online portal at aca3.accela.com/FTL. After you sign in, choose Apply > Permits/Engineering (ROW). The city's Permit Solutions team can help with online applications at 954-828-6520, option 1.
I live in Sailboat Bend. What extra approval do I need?
A Certificate of Appropriateness for any work that changes the outside look of a designated property. Matching replacements can be reviewed by the Historic Preservation Planner; other changes go to the monthly Historic Preservation Board. Start at the Urban Design and Planning counter before you apply for the building permit.
My mailing address says Fort Lauderdale. Does the city issue my permit?
Not always. Some Fort Lauderdale ZIP codes extend into other municipalities. The permitting office is set by the property's actual city, not the ZIP. Confirm your jurisdiction before you apply, because each city has its own portal and checklist.