Hurricane code · Pompano Beach · Broward County

Hurricane window code in Pompano Beach: what applies to your home

Pompano Beach is in Broward County's High-Velocity Hurricane Zone, so every new or replacement window needs a permit and a Miami-Dade NOA or Florida Product Approval. Design wind speed is 170 mph under FBC Section 1620.2. Condo towers over 30 feet need engineer-sealed wind loads, and condos and HOAs need an association approval letter.

Last checked: October 24, 2026 · General information, not engineering or legal advice. Confirm requirements for your address with the building department.

Pompano Beach is a condo city first, and the rules follow

Most window code pages assume a single-family house. In Pompano Beach that is the minority case. Of about 61,070 housing units, roughly 29% are single-family detached homes. About 41% sit in buildings with 20 or more units, and about 30% are in buildings with 50 or more units.

That matters because the city's window rules split by building height and by ownership type. A house in Cresthaven or Pompano Beach Highlands and a unit in a beachfront tower follow the same base code but take different paths to a permit.

About 45% of occupied homes are rented. Renters do not apply for window permits; the owner or association does.

The base layer: High-Velocity Hurricane Zone and a 170 mph wind speed

Broward County and Miami-Dade County together form the High-Velocity Hurricane Zone (HVHZ) in the Florida Building Code. It holds the strictest wind provisions in the state code, and all of Pompano Beach is inside it. The code in effect is the Florida Building Code, 8th Edition (2023), which took effect December 31, 2023.

Inside the HVHZ, the code does not take wind speed from a map reading. Section 1620.2 of the 2023 Florida Building Code sets 170 mph, a 3-second gust, for Risk Category II buildings across Broward, Pompano Beach included. The pressure each window must resist still depends on its height, wall zone and size.

Older paperwork may cite the earlier Broward chart (2017 code, ASCE 7-10), built on 170 mph with Exposure C. The chart posted now uses ASCE 7-22, so ask which one a new permit will use.

For scale: during Hurricane Wilma on October 24, 2005, the National Weather Service recorded Pompano Beach at 83 mph sustained with a 98 mph peak gust. The code plans for a stronger storm than either.

NOA or Florida Product Approval, marked up for the city

For any window, door or shutter permit, Pompano Beach requires a current Miami-Dade Notice of Acceptance (NOA) or a Florida Product Approval. The city accepts either, with one extra step: every element of the approval that applies to your job must be circled or clouded on the copy you submit. That tells the reviewer which size, glass, anchors and design pressure you rely on.

  • Match the tested size range to each opening.
  • Match the tested design pressure (+/- psf) to the pressure required for that opening.
  • Note the anchor and buck details the approval calls for. A Florida engineer or architect may modify the buck or fasteners with a signed and sealed letter or drawing.

The 30-foot line: houses and townhomes vs. condo towers

Broward's Board of Rules and Appeals Formal Interpretation #24 (revised January 9, 2025) governs window, door, garage door and shutter retrofits for detached one- and two-family homes and townhouses with a roof height under 30 feet.

Above 30 feet, design wind loads must be site-specific and signed and sealed by a Florida engineer or architect. Generic charts are not accepted. In Pompano Beach that covers the mid- and high-rise condos along the beach and the Intracoastal.

How design pressure is set for a Pompano Beach window retrofit (Broward BORA FI #24)
BuildingAccepted ways to set design pressure
Detached house, duplex or townhouse, roof under 30 ft(a) Signed-and-sealed site-specific plan; (b) unsealed plan plus a sealed worst-case pressure chart; or (c) unsealed plan using the Broward County Fenestration Voluntary Wind Load Chart
Any building with mean roof height over 30 ftSite-specific design wind loads signed and sealed by a Florida engineer or architect only

Reading the Broward wind load chart for a low-rise home

For homes under 30 feet, the voluntary chart lists wall pressures by mean roof height (15, 20, 25 or 30 feet), wall zone and tributary area, plus worst-case garage door pressures. Zone 4 is the field of the wall; zone 5 is near the corners, where pressure runs higher. Two identical windows on one wall can need different ratings.

How old is your home? Pompano Beach by building era

Pompano Beach's housing is older than its beach-town image suggests. The median year built is 1974. About 82% of units were built before 1990 and about 87% before 2000. The 1970s alone account for about 30% of units, and the 1960s about 22%.

Most windows in place were not installed under today's HVHZ product rules. Replacing them is a retrofit, and new products must meet the current code.

Pompano Beach housing by decade built (ACS 2020-2024)
BuiltShare of unitsWhat it usually means for windows
1960sAbout 22%Original or early replacement openings; retrofit to current HVHZ rules
1970sAbout 30%Largest group, including many condo buildings now past 25 years
Before 1990 (total)About 82%Most homes and buildings predate today's product approval system
Before 2000 (total)About 87%Few buildings were built under recent code editions

Condo buildings: association letters, catwalks and safety inspections

For condominiums and HOAs, Pompano Beach requires an association approval letter for the scope of work with every window, door or shutter permit. Owner/builder permits are not allowed for condo work, so unit owners need a contractor to apply.

Many Pompano Beach condos have open-air catwalks. The city has a specific rule: where a catwalk is next to a door, the door in any position may not block more than half of the required walkway width. If the existing door already encroaches, a photo of its current condition is required.

Two building-wide programs also touch window work. Florida Statute 553.899 requires milestone inspections of condo and co-op buildings three or more habitable stories tall by December 31 of the year the building turns 30, then every 10 years; the local building official may move that to 25 years near salt water. Pompano Beach also enforces Broward's Building Safety Inspection Program for buildings 25 years or older. Owners get a mailed notice between June 1 and August 31, then have 180 days to file an engineer's or architect's report and 180 days to finish repairs. One- to four-family homes of three or fewer stories, fee-simple townhouses and buildings under 3,500 sq ft are exempt.

With so many 1960s and 1970s buildings, ask your association whether a report is pending before you plan unit windows.

Flood zones, the A1A line and tidal canals

Pompano Beach has about 3 miles of beachfront running north to the Hillsboro Inlet. According to the city, FEMA maps place over 32% of buildings in a Special Flood Hazard Area, and the whole city can potentially be considered flood prone. The city's flood form lists zones AE, AH, VE and X.

The city treats properties east of State Road A1A as a coastal zone with greater flood risk from waves and storm surge. Inland, the Pompano Canal and Cypress Creek Canal drain into the Intracoastal, and many waterways are tidal, so heavy rain at high tide can back up stormwater.

Flood zone does not change the product approval. Check your lot in the city's online flood zone lookup.

The Pompano Beach window permit, in brief

Installing, replacing or doing a major repair of any window or door needs a building permit, and so do shutters. Swapping a part that does not alter the product's approval does not.

Permits come from the Department of Development Services, Building Inspections Division, on the 3rd floor of City Hall, 100 West Atlantic Blvd., Pompano Beach, FL 33060, (954) 786-4600. The city uses two online systems with separate logins: Click2Gov to create the application number and pay fees, and ePlan on Avolve to upload PDF plans, answer comments and download the approved plans and permit card. Paper submittals are scanned, and scanning fees apply.

  1. Gather the approvals. NOA or Florida Product Approval for each product, with the applicable parts circled or clouded.
  2. Fill in the retrofit schedule. The Broward County Uniform Retrofit Window & Door Schedule lists each opening's ID, approval number, tested and required pressures, size, area, wall zone, impact glazing, shutters and mullion tubes.
  3. Add the plan and pressures. A plan showing location, size and type of each product, plus the wind load chart or sealed loads that fit your building height.
  4. Add the paperwork. Broward County Uniform Permit Application, the association letter for condos and HOAs, an owner/builder affidavit if used, and a recorded Notice of Commencement when the contract price is above the amount set in the city checklist.
  5. Submit and wait for issuance. Building, electrical, mechanical, plumbing and outside agencies review at the same time. The permit is issued electronically after fees are paid, and work cannot start before then.
  6. Pass two inspections. BLDG ATTACHMENT and BLDG FINAL STRUCTURAL, plus a Fire Department Final where a fire permit applies. Keep the approved plans and permit card on site.

What to gather before you ask for a written quote

These are the details that change the product and the paperwork in Pompano Beach. Send your measurements with this list, or call (754) 303-7130.

  • Building type and mean roof height: under or over 30 feet.
  • Condo, HOA or neither, and whether the association has a window spec or a safety inspection report pending.
  • Width and height of each opening, and which ones sit near a building corner (zone 5).
  • Whether any door opens onto a shared catwalk.
  • Whether the property is east of A1A, and its flood zone from the city lookup.
  • After installation, a wind mitigation inspection (form OIR-B1-1802) can document opening protection for your insurer.

Pompano Beach questions

Is Pompano Beach in the High-Velocity Hurricane Zone?
Yes. Pompano Beach is in Broward County, and Broward and Miami-Dade together make up the Florida Building Code's High-Velocity Hurricane Zone. That means the strictest wind rules in the state code apply to every window, door and shutter in the city, whether the home is a house or a condo unit.
What design wind speed applies to a home in Pompano Beach?
Section 1620.2 of the 2023 Florida Building Code sets 170 mph, a 3-second gust, for Risk Category II buildings in Broward. In the HVHZ this fixed figure applies across the city, not a reading from the ASCE wind map. The engineer or building department works out the pressure for each opening.
Does my Pompano Beach condo tower need an engineer for new windows?
If the building's mean roof height is over 30 feet, yes. Broward BORA Formal Interpretation #24 and the city checklist require site-specific design wind loads signed and sealed by a Florida engineer or architect. Generic charts are not accepted above 30 feet. You will also need an association approval letter with the permit.
Can I pull my own window permit as an owner/builder in Pompano Beach?
For a house you own and will live in, often yes, under Florida Statute 489.103. You must appear in person, sign, and supervise the work on site. It is not allowed for condominium work. Selling or leasing within one year of completion creates a presumption the work was done for sale or lease.
Which online system does Pompano Beach use for window permits?
Two. Click2Gov creates the permit application number and takes fee payment. ePlan on Avolve is where you upload PDF plans, respond to review comments and download the approved plans and permit card. They use separate logins, so set up both before you start.
Does living east of A1A in Pompano Beach change my window rules?
The product approval rules are the same citywide. But the city treats properties east of State Road A1A as a coastal zone with greater flood risk from waves and storm surge. The design wind speed is the same 170 mph across the city. Check your flood zone in the city lookup before you plan work.