Hurricane code · Cooper City · Broward County

Which hurricane code applies to windows in Cooper City?

Cooper City is inside Broward County's High-Velocity Hurricane Zone, even though it is inland. Windows and doors need impact-rated glass or an approved shutter, a product approval valid for HVHZ use, and a permit from the Cooper City Building Division. Design wind speed is 170 mph for typical houses.

Last checked: November 3, 2026 · General information, not engineering or legal advice. Confirm requirements for your address with the building department.

Cooper City window rules: why local pages contradict each other

Search for window rules in Cooper City and you will find pages that say the city is inside the High-Velocity Hurricane Zone and pages that say it is outside. Several also quote the Florida Building Code, 7th Edition, which is no longer the current book. They cannot all be right, and the code text settles it.

Section 202 of the Florida Building Code defines the High-Velocity Hurricane Zone, or HVHZ, as Broward and Miami-Dade counties. Cooper City sits in southwest Broward, so it is inside the HVHZ. Being inland does not change that.

The edition in force is the Florida Building Code, 8th Edition (2023), effective December 31, 2023. The Florida Building Commission lists no later edition as in effect yet.

What the HVHZ means for a Cooper City window or door

Inside the HVHZ, buildings must also meet the high-velocity structural sections of Chapter 16, including 1605, 1607, 1611 and 1616 through 1626. Section 1620.2 sets the design wind speed for Broward County at 170 mph (3-second gust) for ordinary Risk Category II buildings, which covers houses and most townhomes.

Section 1626.1 is the one that matters at the window. Glazing in the building envelope must pass the impact test criteria, or be covered by an external protection device that passes them. The large-missile test, TAS 201 and 203, applies to openings up to 30 feet high.

So in Cooper City the question is not whether you need protection. It is which kind: impact-rated glass, or an approved shutter system over ordinary glass. Both can satisfy the code with the right approval.

  • Design wind speed for Broward County: 170 mph for Risk Category II.
  • Protection: impact-rated glazing or an approved external device.
  • Product paperwork: an approval that is valid for HVHZ use.

Which product approval a Cooper City permit will accept

Windows and doors carry either a Miami-Dade Notice of Acceptance (NOA) or a Florida Product Approval. An NOA is evaluated to the HVHZ standards. A Florida Product Approval may or may not be approved for HVHZ use. Its evaluation report says so under Limits of Use, with a line reading Approved for use in HVHZ: Yes or No.

Before you commit to a product, find that line. Send us your opening list and we can check the approval for a series; the number is (754) 303-7130.

Cooper City neighborhoods and ZIP codes at a glance

Cooper City is an inland suburb with no ocean or Intracoastal frontage. The wind-speed number is the same across the city, but the paperwork path changes with the subdivision. ZIP codes are shared with neighbours, so a ZIP alone does not prove you are inside city limits.

Cooper City areas and what to check
AreaZIPWhat it means for windows
Rock Creek33026Family community platted in phases with lakes and parks; sub-pockets include The Park at Rock Creek and Townhomes of Rock Creek. HOA dues appear in listings, so expect HOA review.
Embassy Lakes33026HOA community. Local vendors say it needs architectural review first; confirm with your association.
Monterra33024Gated community between Stirling Road, University Drive, Pine Island Road and Sheridan Street. About 1,200 houses built between 2007 and 2013, the newest in the city.
Country Glen, Cooper Colony Estates, Flamingo GardensvariesOther named neighbourhoods; Flamingo Gardens includes townhomes. Check the association for each.
Shared ZIPs33328, 3333033330 also covers parts of Davie, Fort Lauderdale and Southwest Ranches. 33026 is shared with Pembroke Pines.

Housing age against the code eras

Census aggregators put Cooper City's median year of housing built at 1987, with the largest groups built in the 1980s and 1990s. The figure comes from a secondary source.

That places much of the stock before the 1994 South Florida Building Code changes that followed Hurricane Andrew, and before the statewide Florida Building Code that began in 2002. A home from the 1980s may still have its original windows, or older replacements that were never tested for impact. Such openings were not built to the standard the HVHZ uses today.

Monterra is the exception. Houses built between 2007 and 2013 were permitted under the Florida Building Code, so check their approval labels and permit records rather than assuming. We have no Cooper City figure for the pre-1994 share, so we do not guess one.

The Cooper City Building Division and what it asks for

Permits are handled by the City of Cooper City Community Development Department, Building Division, at 9090 SW 50 Place, Cooper City, FL 33328. The city's own checklists print (954) 434-4300 and Building@CooperCity.gov.

We could not find a Cooper City window-and-door checklist. The city's published checklists open with the Broward County Uniform Building Permit Application, notarized, plus a copy of homeowners association approval if applicable. Broward has required that uniform form in every jurisdiction since April 1, 2016.

Neighbouring Davie, which borders Cooper City along with Pembroke Pines, Hollywood and Southwest Ranches, asks for the application, a Window/Door Installation Form and the Broward Wind Load Chart. Cooper City may ask for similar items; confirm first.

The online portal is unclear. One permit guide names ePermitsOneStop and a contractor page names Accela Citizen Access. Neither is confirmed on a city page we could reach, so ask the Building Division which system is current.

The Broward retrofit rules that set the pressure for each opening

For detached one- and two-family homes and townhouses with a roof height under 30 feet, Broward's Board of Rules and Appeals Formal Interpretation #24 governs the retrofit of windows, doors, garage doors and shutters.

Each opening needs a design pressure, and there are three ways to get it: a signed and sealed site-specific plan; an unsealed plan with a sealed worst-case pressure chart; or an unsealed plan using the Broward County Fenestration Voluntary Wind Load Chart. The chart is based on ASCE 7-22.

Above a 30-foot mean roof height, wind loads must be site-specific and sealed by a Florida engineer or architect. The county's Uniform Retrofit Window and Door Schedule (BORA Policy 20-01) lists each opening's approval, size, pressure and anchorage.

Inland, but not exempt: exposure and flood maps

Broward guidance generally places areas east of the Intracoastal Waterway in wind Exposure D, which the county's voluntary chart does not cover. Cooper City is well west of that line, so the chart is usable for a typical house here.

Cooper City takes part in the National Flood Insurance Program and its Community Rating System. The city notes some residents live in a Special Flood Hazard Area. New FEMA flood maps took effect July 31, 2024, replacing the 2014 maps, and Ordinance 24-12 updated the city's floodplain rules to match.

In Hurricane Wilma, on October 24, 2005, fences and screen enclosures blew away in Cooper City, and more than 5,000 Broward residences were left uninhabitable.

Townhomes, condos and association approval

About 83.8% of Cooper City's housing units are owner-occupied, so most window decisions belong to the owner. In a mandatory HOA, the association review comes before the city permit, not after.

For condo or co-op buildings of three or more stories, Florida Statute 553.899 calls for a milestone inspection by December 31 of the year the building turns 30, then every 10 years. The local building official can move that to 25 years. Broward's Building Safety Inspection Program exempts one- and two-family homes.

Cooper City questions

Do I need a permit to replace windows in Cooper City?
Yes. The Building Division at 9090 SW 50 Place handles permits, and its checklists open with the Broward Uniform Building Permit Application. Ask for the current window checklist and whether your HOA letter is needed before you file.
Is Cooper City in the HVHZ?
Yes. Florida Building Code Section 202 defines the HVHZ as Broward and Miami-Dade counties, and Cooper City is in Broward.
What wind speed are windows designed for in Cooper City?
Section 1620.2 sets 170 mph (3-second gust) for Broward County, Risk Category II buildings. The Broward fenestration chart turns that into a pressure for each opening.
Can I use shutters instead of impact windows in Cooper City?
Yes, if the shutter system has an approval valid for HVHZ use and is permitted. Section 1626.1 accepts impact-rated glazing or an external protection device that meets the same test. Shutters need to be installed before every storm.
Does my Cooper City home need HOA approval for new windows?
Probably, if you are in a mandatory HOA such as Rock Creek, Embassy Lakes or Monterra. The city checklist asks for the association approval letter if applicable.
Do I need a Cooper City NOA or a Florida Product Approval?
Either can work, but a Florida Product Approval must show Approved for use in HVHZ: Yes in its evaluation report. A Miami-Dade NOA is evaluated to the HVHZ standards.