Hurricane code · Dania Beach · Broward County

Which hurricane code applies to windows in Dania Beach?

Dania Beach is inside Broward County's High-Velocity Hurricane Zone, so windows and doors need a Miami-Dade NOA or an HVHZ-approved Florida Product Approval. Broward's design wind speed for ordinary buildings is 170 mph. Permits go through the City of Dania Beach Building Division, and most homes here predate the 1994 code changes.

Last checked: November 3, 2026 · General information, not engineering or legal advice. Confirm requirements for your address with the building department.

Broward's oldest city, with homes to match

Dania Beach started as a settlement called Modello in the late 1890s. The Town of Dania was incorporated on November 30, 1904, which makes it the oldest incorporated city in Broward County. It was re-incorporated as the City of Dania in 1927 and renamed Dania Beach in 1998. Locals still call it the Antique Capital of the South.

That history shows up in the housing. The median year a Dania Beach home was built is 1977 in ACS 2023 data, and the Dania Beach Community Redevelopment Agency's 2024 snapshot puts it at 1976. The biggest group of units dates between 1970 and 1979, with 4,740 units. The next group, 1980 to 1989, has 2,460.

So the typical home here was built before the 1994 South Florida Building Code changes and well before the 2002 Florida Building Code. If your windows are original, they were not designed for today's missile-impact and pressure tests. In 2001 the city annexed several unincorporated Broward areas, adding about 3,600 residents.

Which hurricane code covers windows in Dania Beach

Dania Beach sits in Broward County, and Broward and Miami-Dade together make up the High-Velocity Hurricane Zone (HVHZ). Buildings in the HVHZ must meet the wind-load rules in Section 1620 of the Florida Building Code, which refers to ASCE 7 chapters 26 through 31. The Florida Building Code, 8th Edition (2023) took effect on December 31, 2023.

Section 1620.2 sets the design wind speed for Broward County at 170 mph (3-second gust) for Risk Category II buildings. That category covers ordinary homes and most apartment buildings. Miami-Dade is 175 mph for Category II, so the number is slightly lower here than just across the county line.

Because Dania Beach is inside the HVHZ, the wind-borne debris rule is not optional guidance. Openings need approved impact-rated glazing or approved shutters, and the product must carry the right approval.

Product approval: what to look for on the label

In the HVHZ, a window or door needs either a Miami-Dade Notice of Acceptance (NOA) or a Florida Product Approval number (FL#) whose Limits of Use say it is approved for the HVHZ. Not every Florida Product Approval is. The floridabuilding.org product record is where you check.

HVHZ testing uses three protocols: TAS 201 for large-missile impact, TAS 202 for static pressure and TAS 203 for cyclic loading. A product that passed only the standard Florida test may not qualify here.

  • Ask for the NOA or FL# before you order, not after.
  • Read the Limits of Use for the HVHZ wording.
  • Check that the listed design pressure covers your opening size and wall zone.
  • Keep the approval number, because the permit package lists it for every opening.

The City of Dania Beach Building Division

Window and door permits are handled by the City of Dania Beach Community Development Department, Building Division. Broward County's ePermits contact list shows it at 954-924-6805. The division enforces building codes for new construction, additions, remodeling and interior renovation of residential, commercial and industrial property. Forms and permit FAQs are posted on the city's Building Division page, and general permit questions go to permitting@daniabeachfl.gov.

The city's permit page says applications can be handed in at the Building Department Monday through Thursday between 8:30 am and 3:30 pm. On Fridays there is a drop box at the front door of City Hall. A third-party directory lists City Hall at 100 W. Dania Beach Boulevard, Dania Beach, FL 33004; confirm the address with the city before you drive over.

After the permit is issued, Dania Beach permits are tracked in Broward County's ePermits OneStop site. There you can check status, pay permit fees and request inspections. The city's Business Resources page links to Apply For A Permit and Building Permitting Services. Third-party sites disagree about which vendor runs the intake portal, so use the links on the city's own pages.

What a window permit package needs in Broward

The city did not post a window and door checklist that we could find, so we will not invent one. What we can say comes from county rules that every Broward city applies.

Design pressure for each opening has to come from Broward Board of Rules and Appeals Formal Interpretation #24, revised January 9, 2025, for the 8th Edition code. It covers detached one- and two-family homes and townhouses with a roof under 30 feet. There are three routes:

The chart gives wall pressures by mean roof height (15, 20, 25 and 30 feet), by wall zone and by tributary area. Zone 4 is the field of the wall and zone 5 is near the corners.

The package also uses the Broward County Uniform Retrofit Window & Door Schedule (BORA Policy 20-01, effective July 1, 2020). For each opening it lists the ID, the product approval number, the product's design pressure and the required pressure, the size in inches, the wall zone, whether the glass is impact rated, existing shutters, new shutters and mullion tubes.

Florida's Notice of Commencement is needed when the contract price is above the state threshold. It must be recorded before the first inspection.

  • A signed-and-sealed site-specific plan.
  • An unsealed plan plus a sealed worst-case pressure chart.
  • An unsealed plan using the Broward County Fenestration Voluntary Wind Load Chart, which is based on ASCE 7-22.

Dania Beach neighborhoods and ZIP codes

Directories disagree on exact boundaries, so treat this table as a guide to where the older stock is, not a legal map. The era notes come from the city-wide median, not from block-by-block data.

A mailing address that says Fort Lauderdale or Hollywood does not decide who permits your windows. The city boundary does.

Dania Beach ZIP codes and recorded neighborhoods
Area or ZIPWhat is recordedWhat it means for windows
33004Primary ZIP for Dania Beach; City Hall is in it. Downtown along Dania Beach Boulevard, Edgewood, Griffin Estates and Oakridge appear in its directories.Most likely to hold the original 1970s stock. Check the year built before assuming anything.
33315 (part)Shared with Fort Lauderdale. Croissant Park, Poinciana Park, River Oaks and Tarpon River are listed in the ZIP, but those sit on the Fort Lauderdale side.Only part of this ZIP is inside Dania Beach. Confirm the city on your tax bill first.
33312 (part)Mostly tagged Fort Lauderdale or Hollywood.Same warning: your mailing address may not match the city that issues your permit.
441 Corridor, Alandco, Arapahoe FarmsNeighborhood names recorded by Statistical Atlas.Inland side. Wind design is the same Broward HVHZ rules.
Lake Eden, Mapleridge, Oakwood Hills, River Landings, Riverland WoodsAlso recorded by Statistical Atlas.Individual homes and townhouses are common in names like these; the 30-foot roof rule decides the path.

Condos and apartments: the 30-foot rule and association approval

Dania Beach is heavy on condos and apartments. Only about 24% of units are single-family detached by the latest Census count used by Point2Homes. The CRA's 2024 snapshot says 29%, or 4,800 units. Point2Homes counts 760 units in buildings of 10 to 19 units, 2,312 in buildings of 20 to 49 units and 1,715 in buildings of 50 or more. That is roughly 4,800 units in buildings of 10 or more.

Under Formal Interpretation #24, a building with a mean roof height over 30 feet needs site-specific design wind loads, signed and sealed by a Florida engineer or architect. The generic chart is not accepted above 30 feet. That applies to the mid-rise and high-rise condos along the beach and the Intracoastal.

The owner-occupancy rate is 47.2%, per City-Stats, so renters are the majority of occupied households. A renter cannot pull a window permit; the owner or the association does. Florida's owner-builder exemption (F.S. 489.103) is also not allowed for work inside a condominium.

Most associations require written approval before any change to windows or doors, and many control which product, color and glass you can use. Get that approval in writing before you order, and attach it to the permit if the city asks.

Milestone inspections and Broward's 25-year program

Florida Statute 553.899, from SB 4-D in 2022, requires a milestone structural inspection for condominium and cooperative buildings three or more stories tall. It is due by December 31 of the year the building turns 30, then every 10 years. The local enforcement agency can require it at 25 years based on conditions such as closeness to salt water.

Broward County has its own Building Safety Inspection Program in Section 110.15 of the Board of Rules and Appeals rules. Under Policy 05-05, revised effective August 9, 2024, it requires a structural and electrical inspection once a building is 25 years old. Re-inspection follows every 10 years. That clock runs across the whole county, not only near the coast. One- and two-family homes and minor structures under 3,500 square feet are exempt.

Flood rating, elevation certificates and the beach

Dania Beach takes part in FEMA's Community Rating System and holds a Class 5 rating, according to the city's CRS page. An older South Florida Water Management District assessment listed the city at Class 9, so the rating has improved.

As a CRS community, the city must obtain FEMA Elevation Certificates for new construction and when a building is substantially improved or repaired after substantial damage. The floodplain manager may already have one on file for your address. If your window project is part of a larger remodel, ask the Building Division whether the substantial-improvement rule is in play. We did not find the city's FEMA flood-zone breakdown, so we are not guessing which streets are in which zone.

Beachfront properties have one more local issue. Each Broward beach city enforces its own sea-turtle lighting ordinance. A 2021 Local 10 report covered lights from a city-owned pier building in Dania Beach that were blamed for sea-turtle deaths. The state model rule is Florida Administrative Code 62B-55.004. We did not find the text of Dania Beach's ordinance, so ask the city whether your glass or exterior lighting is affected.

Shutters or impact windows in Dania Beach

Either can satisfy the HVHZ opening-protection rule if the product is approved and the pressure rating covers the opening. The Broward retrofit schedule has columns for existing shutters, new shutters and mullion tubes, so the permit paperwork treats them as options for the same opening.

Impact glass protects all year. Shutters have to be deployed before each storm.

Neighboring cities

Dania Beach borders Fort Lauderdale to the north and Hollywood to the south. The Broward county rules above are the same on both sides, but each city runs its own permit office, hours and intake process. If your lot is close to a border, confirm the city before you call the wrong office.

Dania Beach questions

Do I need a permit to replace windows in Dania Beach?
Yes. Window and door replacement goes through the City of Dania Beach Building Division, which you can reach at 954-924-6805. The package needs the product approval number, the opening sizes and design pressures. Once issued, use Broward ePermits OneStop for status, fees and inspections.
Is Dania Beach in the HVHZ?
Yes. Dania Beach is in Broward County, and Broward and Miami-Dade together form the High-Velocity Hurricane Zone. HVHZ windows and doors need a Miami-Dade NOA or a Florida Product Approval whose Limits of Use say it is approved for the HVHZ.
What wind speed are windows designed for in Dania Beach?
Section 1620.2 of the 2023 Florida Building Code sets 170 mph (3-second gust) for Risk Category II buildings in Broward County. The pressure on a specific opening also depends on roof height, wall zone and opening size, so use the Broward chart or an engineer's plan.
Can I use shutters instead of impact windows in Dania Beach?
Approved shutters can protect openings in the HVHZ, and the Broward retrofit schedule lists them alongside impact glass. The shutter needs its own approval and a rating that covers the opening. Ask the Building Division how your older frames are handled.
Does my Dania Beach condo need association approval for new windows?
Usually yes. Most associations require written approval before windows change, and the owner-builder exemption does not apply inside a condominium. Buildings over 30 feet also need site-specific sealed wind loads under Broward Formal Interpretation #24.
How do Dania Beach condo recertification rules affect windows?
Condo buildings of three or more stories need a milestone inspection at 30 years under F.S. 553.899, and Broward's own program inspects buildings at 25 years anywhere in the county. Keep the approval records for each replaced opening, because inspectors and boards ask for them.